ClarionメーカーUngo MS2004の使用説明書/サービス説明書
ページ先へ移動 of 20
.
C ongratulations on your purchase of this Ungo System. Please read this manual thoroughly to familiarize yourself with your system’s components and operation. Discuss any questions you might have with your installing dealer. Record the serial number of your Ungo system and keep all dealer records and receipts.
Table of Contents 1. About Your Ungo Security System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 1 2. Remote Transmitters Remote Transmitter Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.
Ungo Security Systems are state-of-the-art vehicle protection systems equipped with features designed to: p Deter potential intrusions to the vehicle by continually flashing the system LED status indicator while the system is Armed, giving a visual indication to any passer-by that the vehicle is equipped with a security system.
Page 2 - MS2004 Owner’s Manual Remote Transmitter Layout The Ungo MS2004 comes with 2 multi-function Remote Transmitters used to control nearly all of the system’s features. Each time a transmitter button is pressed, the LED will flash to indicate that a transmission is taking place.
MS2004 Owner’s Manual - Page 3 Battery Replacement Your Ungo Remote Transmitter uses a 12 volt alkaline battery, which will need to be replaced from time to time. Under normal conditions, the battery may last for up to a year before it needs replacement.
Page 4 - MS2004 Owner’s Manual Remote Arming When Armed, the system monitors and protects 4 independent areas, or zones , including the doors, hood/trunk, shock sensor and optional sensor. To Arm the System: 1. Turn off the ignition. 2. Press Button 1.
MS2004 Owner’s Manual - Page 5 To Bypass the sensors: 1. After arming the system, press Button 1 again on the Remote Transmitter within 5 seconds. • The siren will chirp 5 times, indicating the sensors have been bypassed. 2. The sensors will remain bypassed until the next time the system is armed.
Page 6 - MS2004 Owner’s Manual Arming Mode Selection Your system can be set in one of the following Arming Modes: • Passive (automatic) Arming with chirp confirmation • Active Arming (by Remote Only) • Passive (automatic) Arming without chirp confirmation To set the Arming Mode: 1.
MS2004 Owner’s Manual - Page 7 To enter Panic Mode: 1. Press and hold Button 1 for 3 seconds. • The siren will sound. • The doors will unlock. 2. Press Button 1 again to stop panic and place system into the Armed state. 3. Press Button 2 to stop panic and place system into the Disarmed state.
Page 8 - MS2004 Owner’s Manual 6. Enter the code again and hold for 10 seconds on the last press. • The siren will chirp 3 times. • The parking lights will flash 3 times. • The LED will flash a number of times equal to the new code. 7. Release the switch.
MS2004 Owner’s Manual - Page 9 Valet Mode Allows you to temporarily disable the security system when the car is being service or turned over to a parking attendant. To turn Valet Mode on or off: 1. Turn on the ignition. 2. Press and hold the override switch.
Dome Light Control For increased safety and convenience this optional feature will automatically turn on the dome light when you Disarm the system. With this feature installed, the dome light will turn on for 30 seconds when the system is disarmed (or unlocked in Valet Mode) using the Remote Transmitter.
Remote Car Starter When an optional Remote Car Starter is installed into your car, the Remote Transmitter can be used to remotely start and run your vehicle to warm-up the engine, as well as activate the heating / air conditioning system.
Page 12 - MS2004 Owner’s Manual Notes.
MS2004 Owner’s Manual - Page 13 Notes.
Page 14 - MS2004 Owner’s Manual Technical Data Specifications Main Unit Voltage: 12v, negative ground Current Consumption: <15mA Temperature Range: -40 o F to +257 o F Auxiliary Output Capability: 500mA Internal Relays: (1) 30A, (3) 15A Transmitter Current Consumption: <.
MS2004 Owner’s Manual - Page 15 1. Ungo Security Corporation of Gardena, California ("Ungo Security") warrants this Ungo system to be free from defects in materials and workmanship and to comply with Ungo Security’s applicable printed specifications.
Ungo Security Corporation A Clarion Company 661 West Redondo Beach Blvd. Gardena, CA 90247 800-Go-Clarion www.clarion-usa.com © Ungo Security Corporation, Gardena, CA 97-MS2004-10 Rev.
デバイスClarion Ungo MS2004の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Clarion Ungo MS2004をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはClarion Ungo MS2004の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Clarion Ungo MS2004の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Clarion Ungo MS2004で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Clarion Ungo MS2004を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はClarion Ungo MS2004の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Clarion Ungo MS2004に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちClarion Ungo MS2004デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。