Combiメーカー8000 Seriesの使用説明書/サービス説明書
ページ先へ移動 of 18
Ty r o ™ 8000 Series Instruction Manual Ty r o ™ Infant Car Seat C MBI ® L A T C H L o w e r A n c h o r a n d T e t h e r f o r C H i l d r e n • Certified for use in motor vehicles and aircraft. • Meets or exceeds all applicable requirements of Federal Motor V ehicle Safety Standard 213.
Section 1. T able of Contents.................................................................................................... .................. 1 Section 2. W arnings................................................................................
• Proper use is required. Read and understand instructions and car seat labels. • Use this infant car seat rear-facing only . • Snugly adjust harness straps around child. • Securely install car seat with LA TCH System or vehicle seat belt as specified in this instruction manual.
5 INF ANT CAR SEA T Shoulder Harness Slot Chest Clip Harness Adjuster Lever Crotch Strap Carry Handle Canopy Not Shown (see page 24) V ehicle Lap Belt Guide (Without Base) Shoulder Harness Strap Metal.
3 1 Position harness to fit infant: - Shoulder harness straps must be through shoulder harness slots at or just below infant’ s shoulders. - Infant insert MUST be used for small infants. See “Operations and Adjustments” section to change position of harness.
National Highway T raffic Safety Administration (NHTSA) alerts vehicle owners that according to accident statistics, children up to age 12 are safer when properly restrained in the rear seating positions rather than the front seating positions. Refer to vehicle owner ’ s manual for car seat installation instructions for your vehicle.
LA TCH System On This Car Seat: The LA TCH System on the T yro ™ Car Seat consists of a lower anchor belt with lower anchor connectors . The lower anchor connectors on the car seat connect to the LA TCH System in a vehicle.
13 Attaching Infant Car Seat T o Base: V erify that there are no objects on top of base or between base and infant car seat. Lower car seat into base and push down on car seat to lock car seat into base (fig. b) . T est to be sure car seat is locked in base.
15 Attach car seat to base. Adjust recline using recline indicator on the side of the car seat. Line of recline indicator MUST be in green striped zone (fig. e) . If line is not in green striped zone, adjust base (see “Base Adjustment” section), and recheck recline of car seat.
17 Securing Base With V ehicle Seat Belt: Refer to vehicle owner ’ s manual to identify the seating locations which can be used with a car seat. Check for specific instructions for car seat use. After selecting a seating location, adjust vehicle seat back into most upright position.
Securing Infant Car Seat W ithout Base: Refer to vehicle owner ’ s manual to identify the seating location which can be used with a car seat. Check for specific instructions for car seat use. After selecting a seating location, adjust vehicle seat back into most upright position.
21 This infant car seat can only be used with COMBI stroller models to transport your infant. Check COMBI stroller information or the COMBI International website at www .combi-intl.com, for an updated list of stroller models. See stroller instructions for securing car seat and use information.
23 Harness Use and Adjustment Harness Strap Adjustment: •T o tighten: Pull front adjuster strap (fig. a) . •T o loosen: While pressing harness adjuster lever , pull harness straps out. Chest Clip Operation: •T o open: Press tabs and pull apart (fig.
25 To provide a secure installation of the car seat: • Read the vehicle owner ’ s manual regarding car seat installation and vehicle seat belt use with car seat.
27 Lap belts with retractors (fig. d) may or may not hold a car seat securely . Follow these steps to determine if you have a retractor system that will hold car seat securely: a. Pull belt all the way out. b. Allow belt to retract about 6 inches (15 cm).
The vehicle lap belt must be tight around the car seat and must stay tight. Check for a secure installation - pull front to back and side to side. If the car seat is not tightly secured, remove the belt lock-off and repeat steps 1 and 2.
31 Cleaning Seat: T o Remove Seat Pad: 1. Remove shoulder harness. 2. Slide seat pad from car seat by gently pulling it of f the top of car seat back. T o Launder Pad: 1. Machine wash separately in cold water - delicate cycle, no bleach, and drip dry .
C MBI ® Designed by Parents, for Parents Keep this instruction manual for future use. Store instruction manual inside LA TCH storage compartment located on front of lower base.
デバイスCombi 8000 Seriesの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Combi 8000 Seriesをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCombi 8000 Seriesの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Combi 8000 Seriesの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Combi 8000 Seriesで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Combi 8000 Seriesを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCombi 8000 Seriesの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Combi 8000 Seriesに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCombi 8000 Seriesデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。