CrimeStopperメーカーRS-1604TW1の使用説明書/サービス説明書
ページ先へ移動 of 20
RS - 1604 TW1 / RS - 1704 TW2/RS - 1804 FM RS1 905 FM 2 - Way Paging Remote Engine Starting & Keyless Entry System with 1 - Way Sidekick Remote Control OPERATING INSTRUCTIONS - PRIMARY: These are features that must be connected in order for the system to operate prop erly i.
2 TABLE OF CONTENTS Operation Cautions & Warnings …. …… …………..….…………………………………….………………… ... ……… 2 2 - Way Paging LED Remote TW1.........…………………………………………………………… .
3 2 - WAY PAGING LED REMOTE RS - 1604 TW1 TWO - WAY PAGER OPERATION & PAGE TONES: FEATURE BUTTON ACTION BEEPS LED/FLASH LOCK #1 (Lock) Press & Release 1X then 1X again Orange / 1X UNLOCK #2 (Unlock) Press & Release 1 X then 2X again Green / 2 X AUX #1 #3 (Trunk) Press & Hold 2 Sec.
4 #2 UNLOCK LCD SCREEN #4 ENGINE START/STOP #1 LOCK #3 TRUNK #5 RECALL CAR I or II FIXED ANTENNA AM OPERATION: BUTTON 1 (LOCK Symbol): • Press and release to Lock doors. • Press and Hold for more than 3 seconds to activate “ Panic” feature. BUTTON 2 (Unlock Symbol): • Press and release to Unlock doors.
5 2 - WAY PAGING LCD REMOTE RS - 1804FM/ 1905 FM #1 ARM/ LOCK #4 ENGINE START/STOP #5 RECALL / CAR I OR II #3 TRUNK POP #2 DISARM/ UNLOCK ANTENNA START FIXED LCD SCREEN PM PM PM PM PM IGN PM IGN (<.
6 USING THE 1 - WAY REMOTE The transmitter supplied wit h the CoolStart system contains four buttons , flashlight, and vehicle 2 switch. The button configuration of the CoolStart system is Factory - set and unchangeable. See Page 1 6 for additional information on how to use your remote to operate a second vehicle equipped with a CoolStart system.
7 USING THE 1 - WAY REMOTE RS - 1905FM START LOCK UNLOCK REMOTE #4 #3 #2 #1 2ND VEHICLE TRUNK (AUX#3) (AUX#2) (AUX#4) STARTER #5 COOL START The transmitter supplied with the RS - 1804FM/1905FM system has five buttons. The button configuration of the RS - 1804FM/1905FM is Factory - set and unchangeable.
8 REMOTE ENGINE STARTING REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press the remote start button for at least 1/2 second (Default) or twice if set for double press . 2) Parking lights flash once; return sol id, and the Ignition/Acc circuits turn on.
9 REMOTE ENGINE STARTING Cont. ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock system (If equipped) or open door with key. 2) Enter vehicle and be careful not to step on brak e pedal! (Remote Start Reset) . 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park.
10 REMOTE ENGINE STARTING IDLE DOWN MODE - EXITING THE VEHICLE: 1) With v ehicle engine running with key, ** press the Remote Start button for at least a 1/2 second or twice if set for double press . 2) Parking Lights will turn ON. 3) Doors will unlock, or if brake pedal is being depressed, doors will unlock when it is released.
11 REMOTE ENGINE STARTING INFINITY RUN MODE – EXITING THE VEHICLE: 1) With vehicle engine running with the key, ** press the Remote Start button for at least 1/2 second, pause a few seconds, then press and release the remote start button a second time.
12 TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the CoolStart system to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit t he vehicle, and lock the doors remotely. This is handy for turbo cool - down without the need for expensive turbo timers.
13 CONVENIENCE AND S AFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra la bor and/or parts to install.
14 CONVENIENCE AND SAFETY FEATURES V ALET MODE / STARTER DISABLE OVERRIDE Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode.
15 TRANSMITTER PROGRAMMING Note: All transmitter codes must be learned at time of programming!! The unit will learns up to 4 different transmitter codes. 1. Open Hood (If no hood pin installed with your system, then you must ground the Gray Hood pin wire).
16 COOLSTART VEHICLE #2 Press side button first, then you have 3 seconds to control vehicle #2. 1 WAY SIDEKICK REMOTE 2 - VEHICLE OPERATION A single remote can control two different vehicles Cool S tart systems installed . However, both systems must be the same type.
17 2 - VEHICLE OPERATION Cont. L.E.D Two - way Remote In step #4 of transmitter programming (see Page 1 5 ), press and hold the side button on the LED remote for 5 seconds. The unit will beep 2 times and a yellow LED will flash (now you are in 2 nd vehicle operation mode).
18 TROUBLESHOOTING cont. NO RESPONSE FROM REMOTE TRANSMITTERS: (4 Parts) 1. Check for proper power/ground wiring connections a t module. 2. Check Antenna Module connection. The antenna module included with this system must be plugged in. 3. Transmitters may need to be programmed to the unit.
19 LOW BATTERY WARNING LOW BATTERY WARNING - LCD REMOTE ( RS - 1604TW1 / RS - 1704TW2 ) RS - 1604TW1 ( LED system) : When the battery is low the orange and green LED flash 6 times with any button pres sed. RS - 1704TW2 / RS - 1804FM/1905FM (LCD SYSTEM): When the battery is low , a low battery icon turn s on.
SETTING THE CLOCK (2 - WAY - LCD REMOTE) RS - 1704 TW1 1. Press the Recall button #5 on the side of the remote control 5 times. 2. The remote will beep and the AM or PM display will begin flashing. 3. Pres s the Lock button #1 to increase time. 4. Press the U nlock button #2 to decrease time.
デバイスCrimeStopper RS-1604TW1の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
CrimeStopper RS-1604TW1をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCrimeStopper RS-1604TW1の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。CrimeStopper RS-1604TW1の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。CrimeStopper RS-1604TW1で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
CrimeStopper RS-1604TW1を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCrimeStopper RS-1604TW1の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、CrimeStopper RS-1604TW1に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCrimeStopper RS-1604TW1デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
