GerathermメーカーDesktopの使用説明書/サービス説明書
ページ先へ移動 of 17
GB Fully Fuzzy Auto Digital Blood Pressure Monitor INSTRUCTION MANUAL.
GB Information Y ou Should Know Before Opera- ting the Unit About the Unit ................................................. 25 Explanation of Displays ................................ 25 Preparation for Use Installing/Replacing Batteries ............
GB Information Y ou Should Know Before Operating the Unit 23 What is blood pressure? A force is created by the heart as the ventricle forcibly ejects blood into the blood vessels and through the transport system. Another force is cre- ated by the arteries as they resist the blood fl ow .
GB 24 What about low blood pressure? In general, a lower blood pressure reading is better unless it causes some uncomfortable symptoms such as fainting and/or lightheadedness. Fluctuation and variation in blood pressure The following chart shows possible blood pressure fl uctuations during a 24hr period.
GB About the Unit 25 The cuff is designed to fi t arm sizes between 22 and 32cm (8.7 to 12.6 inches.) Explanation of Displays Cuff On/Off Button Date/T ime LCD Display Memory Button Systolic Pulse Di.
GB 26 Installing/Replacing Batteries 1. Insert the batteries into the battery compartment matching correct polarities „+“ and „-“. 2. Replace all batteries if the low battery indicator appears. 3. Remove the batteries if the unit will not be used- for a long period of time.
GB Preparation for Use 27 Attaching the Pressure Cuff 1. Wrap the cuff around the left arm. The arm should be bare skin. 2. Fasten the cuff. Don‘t pull it strongly and make the cuff too tight. The cuff‘s edge should be ap- proximately 1 inch from crook of the arm.
GB 28 Measuring Positure 1. Sit upright and ensure that the measuring site is at heart level. Relax and measure in a natural position. 2. Measure and record blood pressure at the same time every day to establish your blood pressure pattern.
GB How to Operate the Unit 29 1.Setting the Clock T o adjust the clock Press the memory key to adjust the values of the ”month”, “date”, “hour”, and “minute” when they are blinking T o enter the setting mode by pressing and holding the memory key for over 3 seconds.
GB 30 2. Measuring Blood pressure Press and release the POWER key to start measuring automatically When the measurement is fi nished, the display will show the measured blood pressure and pul- se value Press the power key to turn off the unit. Otherwise the unit will turn off automatically 150 seconds later .
GB How to Operate the Unit 31 Note: If the symbol appears, it means the unit has detected irregular pulse during measurement. If the symbol appears regularly ple- ase consult a qualifi ed physician for professional advice. 3. Recalling Memories Press and release the MEMORY key to recall the last reading (Example: the no.
GB 32 4. Erasing Memories Y ou may erase one or all records in memory . Delete one Record 1. Press and release MEMOR Y key to choose the record that you wish to delete 2. Press and hold the POWER key until the display shows “dEL”. 3. Press and release the power key again.
GB Care and Maintenance 33 Do not drop the unit. It is not shock-proof. Do not modify or disassemble the unit or the arm cuff. Do not twist the arm cuff. Use a cloth mois- tened with water or neutral detergent to clean the body of the unit and then wipe it dry .
GB 34 Care and Maintenance Avoid thinner , benzi- ne, and other harsh cleaners. Keep the unit in a suitable place. Avoid high tempera- ture, direct sunlight, high moisture, and dust. Remove the batteries if the unit will not be used for a long time. Do not press the POWER button if the cuff has not been properly wrapped around the arm.
GB Error Message 35 The pressure measu- red was lower than 20mmHg. Please measure again. The pressure measu- red was higher than 300mmHg. Please measure again. Pumping error . Please check cuff and try again The pressure can not be measured due to signal noise.
GB 36 Display System Measuring Method Power Source Measuring Range Accuracy Infl ation Pressure Exhaust Memory Display Low Battery Indicator Auto Power-Off Battery Life Operating Environment Storage Environment Dimensions Weig ht Specifi cations Liquid Crystal Display Oscillometric 4 alkaline type „AA“ batteries (1.
GB Quality Standard 37 The device complies with the Council Directive 93/42/EEC of 14th June 1993 concerning medical devices. A Quality management system, certifi ed according to EN ISO 13485 guaranties the high quality standard of the product.
デバイスGeratherm Desktopの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Geratherm Desktopをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはGeratherm Desktopの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Geratherm Desktopの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Geratherm Desktopで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Geratherm Desktopを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はGeratherm Desktopの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Geratherm Desktopに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちGeratherm Desktopデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。