Kole AudioメーカーPH1-2000Dの使用説明書/サービス説明書
ページ先へ移動 of 20
.
PH4-800 / PH4-1000 / PH4-1400 PH1-2000D / PH1-4000D / PH1-5500D PH2-700 / PH2-1000 / PH2-1500 / PH2-2000 / PH2-2400 OWNERS MANU AL.
.
- 2 - INTRODUCTION Kole Audio amplifiers provide high-performance sound reinforcement for your mobile audio equipment. Its versatility enables compatibility with optional Equalizers, Frequency Dividing Crossover Networks, and other audio processors in a customized system.
- 3 - Before beginning the installation, consider the following: 1. Do you plan to add additional mobile electronics equipment in the future? If you plan to expand your system by adding other components sometime in the future, ensure adequate space is left and cooling requirements are met.
- 4 - CONNECTING THE POWER (Fig.1) CAUTION: AS A PRECAUTION, DISCONNECT THE POWER WIRE FROM THE BATTERY WHILE MAKING THE POWER AND GROUND CONNECTIONS TO THE AMPLIFIER. 4/8 GAUGE (Thicker if planning for additional Amplifiers) wire is recommended for both the power and ground wires.
- 5 - RCA input jacks These RCA input jacks are for use with source units that have RCA or Line level outputs. A source unit with a minimum level of 200mV is required for proper operation. The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering the system.
- 6 - High pass x-over frequency control This control is used to select the desired high pass x-over frequency. PH4-800/PH4-1000/PH4-1400 : The frequency can be adjusted between 40Hz and 250Hz. PH2-700/PH2-1000/PH2-1500/PH2-2000/PH2-2400 : The frequency can be adjusted between 50Hz and 500Hz.
- 7 - LED Will illuminate GREEN to indicate the amplifier is on and operating normally, and will be illuminated RED if the amplifier shuts down due to short circuit, DC offset, or overheating detected by on board protection circuitry. REMOTE Controls the subwoofer amplifier gain, from a remote location for ease of adjustment during listening.
- 8 - MASTER MODE CONFIGURATION PH1-2000D / PH1-4000D / PH1-5500D 1.Lowest Recommended Impedance is 1ohm mono. 2.RCA Inputs are connected to both Left and Right channels 3.
- 9 - STRAPPED CONFIGURATION PH1-2000D / PH1-4000D / PH1-5500D STRAPPED 2-4ohms 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 10 - 2 CHANNEL STEREO CONFIGURATION PH2-700/1000/1500/2000/2400 HEAD UNIT FRONT P ANEL REAR P ANEL 2 CHANNEL BRIDGED CONFIGURATION PH2-700/1000/1500/2000/2400 HEAD UNIT FRONT P ANEL REAR P ANEL 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 11 - 2 CHANNEL TRI MODE CONFIGURATION PH2-700 / PH2-1000 / PH2-1500 / PH2-2000 / PH2-2400 HEAD UNIT 1.Lowest Recommended Impedance is 4ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 12 - 4 CHANNEL STEREO CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 HEAD UNIT 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 13 - 4 CHANNEL BRIDGED CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 HEAD UNIT 1.Lowest recommended impedance is 4ohm bridged mono 2.RCA Inputs are connected to both Left &Right channels 3.
- 14 - 4 CHANNEL TRI MODE CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 3CH 4-8 Ohms 4CH 4-8 Ohms WOOFER 1CH 4-8 Ohms WOOFER 2CH 4-8 Ohms HEAD UNIT 1.Lowest Recommended Impedance is 4ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 15 - TROUBLE SHOOTING GUIDE Check fuses in amplifier. Be sure Turn-on lead is connected Repair power wire or connections Check connections to radio Check fuse Inspect for short circuit or an open connection. Reverse Left and Right RCA inputs to determine if it is occurring before the amp.
- 16 - MODEL# MAXIMUM POWER OUTPUT POWER OUTPUT @4Ohm POWER OUTPUT @2Ohm BRIDGED POWER THD FREQUENCY RESPONSE -1.0dB HPF LPF SUBSONIC FIL TER BASS BOOST ADJUST ABLE SENSITIVITY RANGE INPUT IMPEDANCE (LOW LEVEL) FUSE DIMENSION (D x W x H inch) PH2-700 700W 2 X 150W 2 X 180W 1 X 360W 0.
- 17 - MODEL# MAXIMUM POWER OUTPUT POWER OUTPUT @4Ohm POWER OUTPUT @2Ohm POWER OUTPUT @1Ohm BRIDGED POWER THD FREQUENCY RESPONSE -1.0dB HPF LPF SUBSONIC FIL TER BASS BOOST ADJUST ABLE SENSITIVITY RANGE INPUT IMPEDANCE (LOW LEVEL) FUSE DIMENSION (D x W x H inch) PH4-800 800W 4 X 80W 4 X 95W - 2 X 190W 0.
- 18 - W ARNINGS Investigate the layout of your automobile throughly before drilling or cutting any holes. Take care when to work near the gas tanks, lines, or hydraulic lines, and electrical wiring. Don't use power amplifier unmounted. Attach this system securely to the automobile to prevent damage, particularly in the event of an accident.
デバイスKole Audio PH1-2000Dの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Kole Audio PH1-2000Dをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはKole Audio PH1-2000Dの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Kole Audio PH1-2000Dの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Kole Audio PH1-2000Dで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Kole Audio PH1-2000Dを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はKole Audio PH1-2000Dの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Kole Audio PH1-2000Dに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちKole Audio PH1-2000Dデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。