Lennox HearthメーカーS260 T-TOPの使用説明書/サービス説明書
ページ先へ移動 of 28
INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance.
2 USING THIS MANUAL Please read and carefully follow all of the instructions found in this manual. Please pay special attention to the safety instructions provided in this manual.
3 IM POR T ANT SA F E T Y AND W AR NI ING IN FOR MA T IO N REA D TH IS MA NU AL IN I TS EN TI RE TY AN D UN DER - ST AND TH ES E RUL ES T O F OL LO W FOR S AF ETY . 1. When this room heater is not properly installed, a house fire may result. T o reduce the risk of fire, follow the installation instructions.
4 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. T o pass inspection in nearly any jurisdiction, the chimney must meet both safety and exhaust flow requirements. The (3’ by) 2’ by 10’ rule applies to both masonry and factor y-built chimneys.
5 This appliance is not designed to be operated in a negative pressure. In very airtight homes with large kitchen exhaust fans, furnace cold air returns, fresh air exchange systems and any other air system in close proximity to the heating appliance may create a negative pressure in the same room as the heating appliance.
6 WARNING: BE ABSOLUTEL Y SURE THE DIST ANCE BETWEEN THE HEA TER AND THE SURF ACE OF ANY COMBUSTIBLE CON- STRUCTION IS NOT LESS THAN SHOWN IN THE DIAGRAMS ON P AGE 7. Floor Protection USA - The floor in front and under the heater must be protected with a mini mum of 3/8” thick non combu stib le mate rial.
7 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Diagram A: T op View-Parallel Installation Diagram B: Side View-Alcove and Parallel Installations Footnotes: 1- These dimensions to the stove body are for reference only . Actual distances should be measured from the stove’ s flue collar .
8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Figure 3 Figure 2 3. First, screw the threaded rods into the holes at the four corners on the bottom of the stove.
9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 1. If not previously installed, install floor protection and move the heater into the desired location. 2. Position the stove on your floor protection in the exact location where it is to be located, making sure all minimum clearances are met.
10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. (For ash drawer pedestal see instructions included with pedestal) Residential and Mobile Homes (Bolting down and grounding are required only in mobile homes) CAUTION: Wear gloves during installation in case of sharp edges on the stove.
11 1. Check that all chimney pipe joints are securely fastened. 2 . Check that the heater is securely fastened to the floor (if applicable). 3. Make sur e the int ake v ent h as c lear access to outsid e ai r (if applicable). 4. Make sure the outside air vent has been sealed properly to keep rodents out (if applicable).
12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. CAUTION: Wear gloves during brick installation in case of sharp edges inside the stove. Note: Installation of the baffle boards and insulating blanket is easier when you can still access the flue outlet (before connecting flue vent).
13 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Be sure to clean the Nickel or Gold Plated door with a house - hold type glass cleaner and a ver y soft cloth to remove any fingerprints and residues prior to the first fire. 1. NEVER USE FLAMMABLE LIQUIDS TO ST ART OR REKINDLE A SOLID FUEL FIRE!! 2.
14 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. W ARNINGS The blower must be plugged directly into a properly grou nded thr ee-p rong re cept acle , 12 0 V AC, 60 Hz, sin gle phase. Do not cut or remove the grounding prong from this plug. Do not route power cord under or in front of appliance.
15 It is important to know that for high, combustion efficient, clean burns, you will need to have sufficient temperatures inside the firebox for thorough combustion . The best method for determining if you have sufficient temperatures is to watch the brick lining in your firebox.
16 DOO R HI NGE S: If doo r hi nge s ne ed l ubr ic ati ng , use an an ti -se iz e com po und (never use oil) available from your Lennox Hearth Products dealer .
17 Problem Solution POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember , the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4 ) .
18 DO NOT : Install or operate this stove before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the stove door without fully opening the draft first. DO NOT : Burn driftwood or wood that has been in salt water .
19 FRONT DOOR P ARTS LIST Item # Ca t . N o De s c ri p ti on 1 H5639 Door Rope Kit, 7/8” Dia. (6’ 2”) 2 H5629 Upper Hinge Pin 3 H5626 Upper Hinge Pin E-Clip 4 H5628 Lower Hinge Pin 6 H5640 Glas.
20 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P AR TS - MODEL S260.
21 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Door Parts Blower Parts 25 29 31 28 27 26 32 30 REPLACEMENT P AR TS - MODEL S260 7 11 10 6 9 5 4 4 1 8 2 3.
22 REPLACEMENT P AR TS - MODEL S260 22 24 18 20 21 23 Leg and Leg Parts NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE..
23 REPLACEMENT P AR TS - MODEL S260 15 18 15 18 19 16 17 19 Ash Drawer Pedestal and Pedestal NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE..
24 PE D E ST ALS ( RE Q U IR E D ) Ca t . N o . Mo d e l De s c ri p ti on 71 1 1 3 WL - PE D Pe d e st a l (ref. form #506033-16) 71 1 1 4 WL -P E D- ASH D A s h D r a we r Pe d es tal (ref. form #506033-15) OR L EG S ( REQ U IR E D ) (ref. form #506033-14) 70 0 0 0 LE G - OL Y -B Oly mpi c S c u lp t u re d Bl a ck s ( 4 p e r p k g .
25 SAFETY / LISTING LABEL - ENGLISH.
26 SAFETY / LISTING LABEL - FRENCH.
27 NOTES.
Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775,216M Rev . E 02/2010 Lennox Hearth Products reser ves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
デバイスLennox Hearth S260 T-TOPの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Lennox Hearth S260 T-TOPをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはLennox Hearth S260 T-TOPの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Lennox Hearth S260 T-TOPの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Lennox Hearth S260 T-TOPで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Lennox Hearth S260 T-TOPを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はLennox Hearth S260 T-TOPの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Lennox Hearth S260 T-TOPに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちLennox Hearth S260 T-TOPデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。