MagnadyneメーカーPL30の使用説明書/サービス説明書
ページ先へ移動 of 8
OWNER’S MANUAL Model: PL30 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including interference that may cause undesired operation.
2 The information enclosed will provide a ready reference of the operation and maintenance of your new remote mobile security system. 1. Exit the vehicle and close all entrances. 2. Press and release the ARM/DIS or LOCK button on the transmitter . The security system will respond as follows: A.
Note: The following information is valid only if your security system has been programmed to automatically arm. 1. T urn off the ignition key and exit the vehicle. 2. Close all protected entrances. After the last protected entrance is closed the horn/siren will chirp one time and the LED indicator will begin to flash fast.
4 Override Operation: (Security System is Armed) 1. Enter the vehicle. (The security system will begin sounding at this point) 2. Place the ignition key into the ignition switch and turn the ignition switch to the “on” position. 3. Within 5 seconds of turning the ignition key “on”, flip the valet switch to the “on” position.
5 Press and hold the ARM/DIS or P ANIC or LOCK button for more than 3 seconds and the security system will respond in the following manner: A. The horn/siren will begin sounding. B. The parking lights will begin flashing. T o turn off the panic alarm, press and release the ARM/DIS or P ANIC button on the transmitter .
6 1. The LED indicator will provide information on 7 modes of security system operation: LED is off = Security system is disarmed. LED is flashing = Security system is armed. LED is flashing fast = Automatic arming timer or RF protection mode timer is counting down.
7 The following is a brief description of the operation of each programmable feature. Any adjustment to the operation of these features must be performed by the dealer who installed your security system.
System Maintenance: The only maintenance that your security system requires is a periodic check of it’ s operation to be sure that all functions are operating properly . The batteries supplied with your transmitter will usually last about 1 year . Heavier usage will shorten battery life.
デバイスMagnadyne PL30の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Magnadyne PL30をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMagnadyne PL30の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Magnadyne PL30の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Magnadyne PL30で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Magnadyne PL30を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMagnadyne PL30の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Magnadyne PL30に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMagnadyne PL30デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。