Niles AudioメーカーTVA50の使用説明書/サービス説明書
ページ先へ移動 of 28
TV A50 STEREO AMPLIFIER/ A UT OMA TED SWITCHER TV A50 B LENDING H IGH F IDELITY AND A RCHITECTURE ® INST ALLA TION & OPERA TION GUIDE DS00395ACA-TVA50.
T ABLE OF CONTENTS Introduction 3 Features and Benefits 4 TV A50 Parts Guide 5 Installation Considerations 11 Installation 13 T rouble- Shooting 23 Specifications 24 Contents 24 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER TV A50 STEREO AMPLIFIER/ AUTOMA TED SWITCHER IMPORT ANT SAFETY INSTRUCTIONS 1.
2 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER 11. Only use attachments/accessories specified by the manu- facture. 12 . Unplug this apparatus during lightning storm or when unused for long periods of time. 13. Refer all servicing to qualified ser vice personnel.
3 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER INTRODUCTION A common challenge in designing whole-house audio/video distribution systems is allowing a local source, such as audio from a bedroom TV , to play through the main system speakers in that room.
4 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER FEA TURES AND BENEFITS • Compact Size - Allows installation on cabinet shelves, side walls or back panels. • RCA Line In Jacks - T wo gold plated RCA jacks for line level audio input from local device.
5 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER TV A50 P ARTS GUIDE 1. AC IN – Removable three-prong IEC compatible power cord. 2. Current Sensing AC Outlet – TV A50 will activate and switch inputs when it senses a current draw from a connected device.
6 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER F igur e 1 F igur e 2 2 1 3 4 5 6 7 8 DS00395ACA-TVA50.qxp 6/1/04 9:51 AM Page 6.
7 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER Speaker (A) T o Speaker (A) Input Right Left Whole House Receiver TV - Local Room Right/Left TV V ariable Line Out TV - Power Cord T o Current Sensing Outlet TV A-50 T o Unswitched Outlet Speaker (A) Out F igur e 3 TV current sense with one speaker pair Right Left DS00395ACA-TVA50.
8 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER Speaker (A) Speaker (A) Out Right Left Whole House Receiver TV - Local Room Right/Left TV V ariable Line Out TV - Power Cord T o Current Sensing Outlet .
9 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER Speaker (A) Speaker (A) Out Right Left Whole House Receiver TV - Local Room Right/Left TV V ariable Line Out TV - Power Cord T o Current Sensing Outlet .
10 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER Figure 6: Bottom of the unit with measurements for wall mounting 5-7/16" 4-15/16" DS00395ACA-TVA50.
11 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER INST ALLA TION CONSIDERA TIONS Location The TV A50 should be installed near the device to be switched, ideally within 15 feet, to avoid signal loss and degradation over long runs of wire. Access to the speaker wires, from the whole- house system and to the local speakers, is also necessary .
12 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER Speakers The TV A50 will remain stable when driving a 4 ohm load. If only one pair of speakers is being driven, 4, 6 or 8 ohm speakers systems can be used. If switching two pairs, 8 ohm speakers must be used.
13 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER INST ALLA TION Preparing for Installation 1. Figure 3 shows a typical application for switching one pair of speakers to a local source using current sensing. Refer to the other system applications for switching multiple speak- er pairs, and use of the T rigger IN/OUT .
14 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER 3. Gradually turn the sensitivity adjustment screw located on the bottom of the TV A50 (Figure 6) until you hear the inter- nal relay of TV A50 switch. This is indicated by a clicking sound inside the unit.
15 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER Installation Caution : T urn the power OFF to all components in the system to prevent accidental shorting or electrical shock. Mounting the TV A50 When possible, the TV A50 should be installed near the device to be switched.
16 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER Connect Whole-House System 1. Locate the 4 pin speaker connector plug for SPEAKER A IN (and remove if plugged in). 2 . Strip 1/4" of insulation from the end of each wire for SPEAKER A IN, coming from the speaker level output of the whole-house system amplifier .
17 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER 3. Use a small flathead screwdriver or your thumbnail to raise the locking tabs, exposing the holes on the removable con- nector plug. 4. Insert each wire into the appropriate hole on the remov- able connector plug, and snap the locking tab down.
NOTE: Some TVs have separate fixed (non-adjustable) and variable line outs. Some need to be switched using the TV’ s on-screen menu. Refer to the TV manual for additional information. Source Switching The TV A50 has two switching modes. Current Sensing and AC or DC voltage trigger .
19 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER BEFORE PROCEEDING SET THE VOLUME CONTROL ON THE TV A50 TO THE MINIMUM POSITION (FULL Y COUNTERCLOCKWISE). 1. Play a source (CD, T uner) on the whole-house system. Set the volume to a normal listening level.
20 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER NOTE : The speaker level, when switched from the whole-house system to the TV will not always be the same. If the whole-house system was set to CD with the volume turned up and the TV gets turned on to it’ s normal listening level, the speaker level might drop when the system switches to TV .
21 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER Example 2: In-W all V olume Control With a Fixed Output Device In some applications, it may be desirable to control speaker level of both the whole-house sources and the TV , or perhaps a local CD or DVD player that might not have a variable output, with the in-wall volume control.
22 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER Integrating a Niles IR repeater system with a TV plugged into the current sensed outlet of a TV A50, and a 12VDC controlled lift mechanism, provides an inexpensive, yet elegant solution to system automation.
23 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER TROUBLESHOOTING TV A50 will not power up Is TV A50 plugged in to an unswitched outlet? Is the POWER/ACTIVE LED Red? 120V AC measured from outlet with voltmeter? T ry another unswitched outlet.
24 S TERE O A MPLIFIER / A UT OMA TED S WIT CHER SPECIFICA TIONS Power : 50 watts per channel RMS into 4/8 ohms. S/N Ratio: >94dB THD: .05% at rated power . Mounting: Horizontal or vertical mount- ing. Keyholes in back panel for vertical mount. Connectors: 12V T rigger IN/OUT : 3.
S TERE O A MPLIFIER / A UT OMA TED S WIT CHER 25 Notes DS00395ACA-TVA50.qxp 6/1/04 9:51 AM Page 25.
S TERE O A MPLIFIER / A UT OMA TED S WIT CHER 26 Notes DS00395ACA-TVA50.qxp 6/1/04 9:51 AM Page 26.
Ni les Audio Corpora tion www .nilesaudio.com 1 233 1 S.W . 1 30 Street Miami, Florida, 3 3 18 6 T el: (305) 238-4373 Fax: (305) 238-0 1 85 © 2004 Niles Audio Corporation. All rights reserved. Niles, the Niles logo, IntelliPad and Blending High Fidelity and Architecture are registered trademarks of Niles Audio Corporation.
デバイスNiles Audio TVA50の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Niles Audio TVA50をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはNiles Audio TVA50の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Niles Audio TVA50の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Niles Audio TVA50で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Niles Audio TVA50を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はNiles Audio TVA50の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Niles Audio TVA50に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちNiles Audio TVA50デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。