Oricomメーカー50の使用説明書/サービス説明書
ページ先へ移動 of 16
Baby Monitor Secure 50 User Guide.
T ABLE OF CONTENTS W ARNINGS AND SAFETY INFORMA TION 1 GETTING ST ARTED 3 YOUR BABY MONITOR 5 BASIC OPERA TION 8 TROUBLESHOOTING 11 PRODUCT SPECIFICA TIONS 12 GUARANTEE 13.
1 W ARNINGS AND SAFETY INFORMA TION IMPORTANT Please read this user guide thoroughly before use. Your ORICOM Baby Monitor is designed to be an aid and should not be used as a substitute for responsible and proper adult supervision of a child.
2 W ARNINGS AND SAFETY INFORMA TION Battery requirements Each parent unit requires two rechargeable Ni-MH batteries, size AAA 1.2V 800mAh (HR10/44). • Do not dispose of the batteries in a fi re, as they can explode. • Do not open, unscrew or temper with any of your baby monitor units or battery.
3 clip battery cover Installation For the Parent Unit 1 Remove the Belt Clip by lifting the clip at the top and sliding it downwards. 2 Then remove the battery cover on the back of the Parent Unit by switching the OPEN switch. Insert the rechargeable batteries (supplied) as marked on the unit and close the cover again.
4 5 Press [ ] to turn the Parent Unit on. • Before fi rst use, or if it has been out of use for a long time, the Parent Unit will need to be charged for 15-16 hours. During this time, the Parent Unit will operate from the Charger pod when switched on.
5 YOUR BABY MONITOR Baby unit (Sender) 1 Night light Key Press to turn On the night light. Press again to turn off the Light. 2 Power On/Off Key Press to turn the Unit ON. Press and hold to turn the Unit OFF. 3 Page Key Press and hold this key, Parent unit makes an audible alert.
6 YOUR BABY MONITOR Left view of baby unit 6 DC 6V input Connecting to Power Adaptor. 7 8 9 10 6 Parent unit (Receiver) 7 Battery Cover Rechargeable batteries. 8 Belt Clip 9 Volume Up/Down Keys Adjust the Volume at which you hear the sounds in your baby's room.
7 Charger Pod 14 Charging Light When Parent unit is placed in the Charger Pod, the red charger light comes ON to indicate the batteries are charging. Light will remain ON to ensure optimum charge is maintained. YOUR BABY MONITOR 12 11 14 11 Power Light Red light when the power is ON.
8 BASIC OPERA TION Once you have set up your Baby Monitor, you will be able to hear the sounds in your baby's room through the Parent Unit. And also see the green and red sensor lights around the top of the Parent Unit rise and fall with the sound levels.
9 BASIC OPERA TION • To stop the Page alert, press any button on the Parent Unit, or press [ ] again on the Baby Unit. Note: If no button is pressed, the paging tone will stop after 30 seconds. If the Parent Unit volume is off, the Parent Unit volume will reset to mid volume.
10 BASIC OPERA TION 8 lights illuminated fully charged 6 lights illuminated half charged 4 lights illuminated battery is running low 2 lights illuminated (alarm beep sounds) batteries need recharging Note: The parent unit can be used on or off the charger pod.
11 TROUBLESHOOTING Problem Possible cause(s) The red power lights do not turn on when you plug in the power. 1. Check if the units are properly connected to the power supply.
12 PRODUCT SPECIFICA TIONS Feature Speci fi cations Operating Frequency DECT 1.8 GHz Range Up to 300m under optimum conditions. The range is reduced in buildings (up to 50m) as a result of walls, doors etc.
13 GUARANTEE Warranty Information (Australia) Oricom makes no other warranties or conditions, express or implied, including as to merchantability and fi tness for a particular purpose, except as stated in this Warranty. Any implied warranties that may be imposed by law are limited in duration to the Warranty Period.
Australia Oricom International Pty Ltd Locked Bag 658 South Windsor, NSW 2756 Customer Support Email: support@oricom.com.au Web: www.oricom.com.au Phone: 1300 889 785 Fax: (02) 4574 8898 Customer Support If you suspect your product is not functioning to speci fi cation, before making a warranty claim please use the following resources.
デバイスOricom 50の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Oricom 50をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはOricom 50の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Oricom 50の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Oricom 50で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Oricom 50を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はOricom 50の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Oricom 50に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちOricom 50デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。