AudiovoxメーカーSS9000の使用説明書/サービス説明書
ページ先へ移動 of 20
128-8842 1 of 20 Page 1 Model SS9000 Owner ’s Manual Long Range Remote St art Security System With Plug-In Shock Sensor & S tarter Disable IMPORT ANT! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry .
128-8842 2 of 20 Page 2 Additional Engine Immobilizer Output, (Optional Relay Required) T rue Last Door Arming (Hardwire Only) Defective Zone By-Pass Defective Zone Chirp Confirmation .
128-8842 3 of 20 Page 3 simply press button 1, (lock), two times within a one second time period. The system will now respond to that transmitter each time a button is pressed. NOTE: This system is custom configurable and can be set up to operate with a number of options controlled from any transmit- ter button or button combination.
128-8842 4 of 20 Page 4 Doors Lock - Optional NOTE: If the optional Headlamp illumination feature has been added and has been selected for operation when arming, as an added convenience, the sys- tem will turn on the headlights when the system is armed.
128-8842 5 of 20 Page 5 DISARMING THE SYSTEM NOTE: If the optional 2 step door unlock circuit is installed, when the unlock transmitter button is activated, the drivers door only will unlock, pressing the unlock button a second time will cause all doors to unlock.
128-8842 6 of 20 Page 6 If the siren sounds 4 chirps, then the alarm was triggered in your absence. Before turning the key on, examine the LED and refer to the INTRUSION WARNING SIGNALS section of this manual to identify which zone was triggered.
128-8842 7 of 20 Page 7 MANUALL Y OVERRIDING YOUR SYSTEM: Using The Receiver's Push-Button Override Switch Y our Security System can be disarmed without the use of the keychain transmitter . This is necessary , since you will need the ability to operate your vehicle if the transmitter is lost or its battery fails.
128-8842 8 of 20 Page 8 1. Disarm the system by use of the transmitter , or by use of the emergency override sequence. 2. Turn the ignition switch to the on position. 3. Within 10 seconds, press and release the Receiver ,s Push-button switch, 3 times.
128-8842 9 of 20 Page 9 3. If the chirps were on before you started, the siren will emit 2 short chirps indicating that the chirps are now off. If the chirps were off before you started, the siren will emit one short chirp indicating that the chirps are now on.
128-8842 10 of 20 Page 10 4. S tage 3 (City Mode) In this mode, the pre-detect chirps will change from six pre-warning tones to a full 10 seconds of warning chirps. The full detect trigger duration will be reduced from 30 seconds to 15 seconds. NOTE: Setting the stage of the shock sensor will be effective for one arming cycle only .
128-8842 11 of 20 Page 11 W ARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicle if it is garaged.
128-8842 12 of 20 Page 12 NOTE: The automatic start up timer can also be initiated from the keychain transmitter . T o do this: 1. S tart the vehicle using the keychain transmitter by pressing and releasing the second channel transmitter button 2 times.
128-8842 13 of 20 Page 13 Right Or Left Slider Doors in An Equipped V an Driver Priority Settings In V ehicles So Equipped T o activate the optional accessory , press the option button on the keychain transmitter . The optional accessory will immediately engage.
128-8842 14 of 20 Page 14 TRANSCEIVER ICONS AND THEIR INDICA TIONS When Disarmed, Press the Arm/Lock button to Lock and Arm the System. The Lock Icon is displayed on the LCD panel & the parking lights flash once. When Armed, Press the Disarm/Unlock button to Unlock and Disarm the System.
128-8842 15 of 20 Page 15 or Trunk. Triggered and entry attempt was made to the vehicles glass, or the vehicle has been hit or bumped hard enough to cause a response from the vibration detector .
128-8842 16 of 20 Page 16 ADDITIONAL REMOTE FEA TURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display , toggle the transmitter from beep tones to vibrate mode, initiate daily start timer , and temperature start.
128-8842 17 of 20 Page 17 NOTE: The unit will start once and run for the prescribed time. If you require more frequent starting please refer to auto start up timer mode shown earlier in this guide. NOTE : T o insure accurate 24 Hour S tart up, it is advisable to reset the start time periodically as time may drift slightly each day .
128-8842 18 of 20 Page 18 Battery Indicator: Y our transmitter has a battery indicator that is shown in the lower left corner of the screen as shown left. This icon indicates a charged battery shown with 3 bars. As the battery discharges, the bars will disappear .
128-8842 19 of 20 Page 19.
128-8842 20 of 20 Page 20 © 2010 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-8842 SS9000 SYSTEM FUNCTIONS A T A GLANCE LED INDICA TOR RAPID FLASHING = P ASSIVE ARM OR REARMI.
デバイスAudiovox SS9000の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Audiovox SS9000をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAudiovox SS9000の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Audiovox SS9000の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Audiovox SS9000で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Audiovox SS9000を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAudiovox SS9000の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Audiovox SS9000に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAudiovox SS9000デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。