Auto Pageメーカーautopage RS-850lcdの使用説明書/サービス説明書
ページ先へ移動 of 31
JAN/07/2003 RS850 OP 1 RS - 850 lcd PROFESSIONAL REMOTE CAR STARTER WITH ALARM SYSTEM & 2 - WAY LCD COMMUNICATION OPERATION MANUAL THIS PRODUCT IS DESIGNED FOR PROFESI ONAL INSTALLATION ONLY.
JAN/07/2003 RS850 OP 2 TABLE OF CONTENTS: A. REMOTE TRANSMITTER OPERATION …………………….………. 4 B. BUTTON LOCK ……………………………………………….……...…. 5 C. LED DISPLAY .……………..……. .……………………….
JAN/07/2003 RS850 OP 3 U. TRUNK RELEASE (CHANNEL 3) OUTPUT ………..……….………13 V. CHANNEL 4 TIMER CONTROL OUTPUT ………..…………………13 W. CHANNEL 5 TIMER CONTROL OUTPUT ………..……………….. 13 X. CHANNEL 6 TIMER CONTROL OUTPUT ……….
JAN/07/2003 RS850 OP 4 As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of. 1. Keep the transmitter out of children’s reach. 2. Do not leave anyone in the vehicle while running on remote control.
JAN/07/2003 RS850 OP 5 LCD DISPLAY TRANSMITTER OPERATION ONLY: Transmitter Button System Function Remark - (C) System’s Trigger Record Check Press within 3 seconds - - (C) System’s Status Check Pr.
JAN/07/2003 RS850 OP 6 C. LED display: LED Function LED Function Off Disarmed Zone 1 / Warn - Away Trigger Slow Flash Armed 2 flashes... pause Zon e 2 / Trigger on Trunk/Hood Flash Passive Starter Disable 3 flashes... pause Zone 3 / Trigger on Door Switch Fast Flash Passive Arming 4 flashes.
JAN/07/2003 RS850 OP 7 System Arm Door Ajar Trunk / Hood Ajar Clear The Flash Icon: Press the button 3 times within 3 seconds will clear the flash icon on the LCD screen transmitter. DEFECTIVE SENSOR R EMINDER: If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.
JAN/07/2003 RS850 OP 8 I. ACTIVE DISARMING – UNLOCK & DISARM: 1. Press button on the transmitter. 2. The siren will chirp twice and parking light flash twice to indicating that the security system is now disarmed. The vehicle’s door will unlo ck and dome light turns on for 30 seconds upon disarming when interfaced with the security system.
JAN/07/2003 RS850 OP 9 OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE: (Factory Default Setting) The Override function may be used if the remote transmitter is lost or inoperative. 1. Enter the vehicle and turn the ignition switch to 'ON’ position.
JAN/07/2003 RS850 OP 10 system must first be disarmed either by using your remote transmitter, or by operating the Manual override sequence. Enter Valet Mode: 1. From the disarmed condition, turn the ignition to “ON” position. 2. Push and hold valet switch for 2 seconds until the LED turns on.
JAN/07/2003 RS850 OP 11 N. TRIGGER THE SYSTEM When armed, your vehicle is protected as follows: 1. Light impact will trigger the warn - away signal. 2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key will trigger the programmed sequence.
JAN/07/2003 RS850 OP 12 O. ANTI CAR - JACKING Warning: If you don't need the car jacking function in this alarm system, be sure to set car jacking feature “OFF”. This system is default setting all car - jacking “OFF”. (See Alarm Feature I - 6 Programming.
JAN/07/2003 RS850 OP 13 P. SYSTEM’S TRIGGER CHECK Press the transmitter first, within 3 seconds press (C) button. It responds with one melody sound and all trigger’s records will immediately displayed on the LCD screen.
JAN/07/2003 RS850 OP 14 1. Press the transmitter button first, within 3 seconds press ( ) button to activate outdoor driver paging function , It responds with chirps of the vehicle, a melody sound and " " in dication flashes on the LCD screen to confirm the function is on.
JAN/07/2003 RS850 OP 15 Press the transmitter (4) and (4) button at the same time to active Channel 4 function. Chan nel 4 is user - programmable timer output. You may program the built - in timer to send a ground signal for any time duration from 1 second to 120 seconds.
JAN/07/2003 RS850 OP 16 When you want to start your vehicle, 1. Pre ss button once on the transmitter. 2. The parking light will activate to indicate the remote start received the signal.
JAN/07/2003 RS850 OP 17 1.Before turning off the engine, pre ss the button twice on the transmitter and the LED indicator will flash 3 times to confirm enter. 2.Turn the ignition key to OFF position. (The engine will stay running.) 3.The engine will run until the pre - programmed time elaps ed or shutdown input is received.
JAN/07/2003 RS850 OP 18 parking light will flash (6) times. The siren chirps (6) times. The veh icle is now programmed to start at the real time of the next day. Your set time for the next day engine start flashes for approx. 3 seconds on the LCD screen.
JAN/07/2003 RS850 OP 19 1. The hood is opened. 2. The brake pedal is pressed. 3. Engine is over - revved. {“Tachometer checking type” only} 4. The pre - programmed run ti me (5 /10 / 20 / 30 minutes) has elapsed. 5. Press button once on the remote transmitter under remote start mode .
JAN/07/2003 RS850 OP 20 Note: If the system is interfered by stronger radio frequency around, sources of high voltage electric power or such Obstacles like tall buildings and so on, the transmission range may get shorter as the system uses low out put powered frequency.
JAN/07/2003 RS850 OP 21 B. THE REMORE LCD ICONS WITH FUNCTION: Door Lock Your vehicle doors are locked Door Unlock Yo ur vehicle doors are unlocked and the system is Disarmed Armed Mode Your vehicle is in armed mode Valet Mode All the function shall be temporarily on hold.
JAN/07/2003 RS850 OP 22 Vibration Mode Remote Control vibra tes when the system is triggered Button Lock Disable the transmission function temporarily Driver paging Someone is paging you in front of your vehicle Low Battery You have to replace the battery of remote control.
JAN/07/2003 RS850 OP 23 1. Screen Lamp ON: Press and hold the button one second, with one melody sound and the LCD screen lamp will turns on for 5 seconds 2. Power Save Mode: While the power save mode, the LCD remote transmitter uses “0” current to save the battery power.
JAN/07/2003 RS850 OP 24 It is useful when you are in a noisy place and difficult to hear b eep sound from the remote control as the remote control in this mode, vibrates itself if your security system is triggered.
JAN/07/2003 RS850 OP 25 1 Press & Hold the button for 3 seconds Timer Setting (Hour) *Flash digit for adjusting for – and for + Press the button once Time setting (Minute) *Flash digit for adjusting for – and for + 2 Press the button once.
JAN/07/2003 RS850 OP 26 1. Press & hold the button for 3 seconds, with two - melody sound and the “Hours” digit flashes for adjusting. 2. Press the button twice, the LCD screen will shows icon a nd “Hours” digit is flashes for adjusting. 3.
JAN/07/2003 RS850 OP 27 Press the button to stop the count down timer, and the “OFF” icon will show on the LCD screen. 8. Press the button for 2 seconds with one - melody sound to confirm exit the timer program mode. Note: Maximum is 19 hours. 4. Time Set - Up For “Daily Timer Start”: Example to AM 6:30 1.
JAN/07/2003 RS850 OP 28 LIMITED LIFETIME WARRANTY PROVISIONS ( U.S. and Continental U.S. Only) 1. AutoPage, Inc. WARRANTS that this new unit has been thoroughly inspected and tested at the factory prior to delivery.
JAN/07/2003 RS850 OP 29 4. Any equipment or parts which are claimed to be defec tive under this WARRANTY must be sent to the AutoPage Service center with “proof of purchase” at the purchaser’s expense prior to such return, a Return Authorization Number should be obtained.
JAN/07/2003 RS850 OP 30 Serial # __________ _____ CUSTOMER TO COMPLETE DEALER TO COMPLETE Mr./Mrs./Ms. ___________________________ ________________________________ Your Name (Please Print) Company Nam.
JAN/07/2003 RS850 OP 31 1815 West 205 th Street Suite 101 Torrance, California 90501 - 1525 Main Office: 310 - 618 - 2002 Customer Service: 800 - 262 - 2527 Ext.
デバイスAuto Page autopage RS-850lcdの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Auto Page autopage RS-850lcdをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAuto Page autopage RS-850lcdの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Auto Page autopage RS-850lcdの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Auto Page autopage RS-850lcdで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Auto Page autopage RS-850lcdを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAuto Page autopage RS-850lcdの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Auto Page autopage RS-850lcdに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAuto Page autopage RS-850lcdデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
