SonyメーカーSAT-B55 RM-Y139の使用説明書/サービス説明書
ページ先へ移動 of 36
SER VICE MANUAL DIGIT AL SA TELLITE RECEIVER/SA TELLITE ANTENNA S A T-A55 RM-Y802 S A T-B55 RM-Y139 SAN-18D3 RM-Y802 SA T-A55 SAN-18D3 U.S. Model 1. SAT A55 B55 front.
— 2 — SA T-A55/B55 UHF/VHF 75 ohm F-type Satellite Antenna 75 ohm F-type RF Remote Antenna (SA T-A55 only) AC Power (120V , 60 Hz) S-VIDEO OUT 4-pin mini DIN VIDEO (RCA jacks) (2) AUDIO R/L (RCA j.
— 3 — SA T-A55/B55 12.2 - 12.7 GHz 950 - 1450 MHz F-T ype Female 3.0 W max. DC + 10.5 - 14.0 V for RHCP DC + 15.5 - 21.0 V for LHCP 18 5/8 x 31 x 18 5/16 inches 473 x 787 x 643 mm 8 lbs 6 oz (3.8 kg) FOR SA TELLITE ANTENNAS: SAFETY CHECK-OUT 1. Check the area of your repair for unsoldered or poorly- soldered connections.
— 4 — SA T-A55/B55 1. General --------------------------------------------------------------------------- 5 2. Disassembly 2-1. Upper Case Removal ---------------------------------------------------- 12 2-2. H Board Removal --------------------------------------------------------- 12 2-3.
— 5 — SA T-A55/B55 The operating instructions mentioned here are partial abstracts from the Operating Manual. The page numbers referenced here reflect those of the Operating Instruction Manual. SECTION 1 GENERAL 8 The SATELLITE IN jack sends power to, and receives satellite signals from, the Satellite D ish Antenna.
— 6 — SA T-A55/B55 10 You can record programs by adding a V CR. You can also connect your Digital Satellite Receiver to an audio system for enh anced sound enjoyment.
— 7 — SA T-A55/B55 12 With the SAT-A55 model you can connect the RF Antenna and opera te the Digital Satellit e Receiver when installed in a cabin et or from another room in your h ouse using the rem ote control. See pa ge 32 for info rmation about how to set up the Digital Sat ellite Receiver to use the RF feature.
— 8 — SA T-A55/B55 14 RM-Y802 Remote Control (SA T -A55 model) Note You may need to set up the remote control to operate your other audio/video equipment. See “Setting Up the R emote Control” on page 65 for detai ls. 1 MUTING button Mutes the volume.
— 9 — SA T-A55/B55 16 RM-Y139 Remote Control (SA T -B55 model) Note You may need to set up the remote control to operate your other audio/video equipment. See “Setting Up the R emote Control” on page 65 for detai ls. 1 MUTING button Mutes the volume.
— 10 — SA T-A55/B55 72 Problem What you can do Poor picture quality or no pictur e • If you are r eceiving only a few stations, (onl y 2 or 3 channels for example), call your service pr ovider to have your programming activated .
— 11 — SA T-A55/B55 74 Y ou cannot record pr ograms with your VCR • Make sure that your VCR is connected correctly (see page 10). • I fy o uw a n tt ou s et h eV C RC o n t r o lf e a t u r e ,m a k es u r et h a tt h e VCR Controller is connected corr ectly (see page 11).
— 12 — SA T-A55/B55 SECTION 2 DISASSEMBL Y 2-2. HB BOARD REMOV AL 2-3. A, SC BOARD REMOV AL Three Screws (BVTT 3 x 8) Upper Case T wo Screws (BVTT 3 x 6) Control Button Four Cla ws HB Board P ower Button F ront Panel 2-1.
— 13 — SA T-A55/B55 NOTES:.
— 14 — SA T-A55/B55 NOTES:.
— 16 — — 17 — — 15 — SA T-A55/B55 SECTION 4 DIAGRAMS 4-1. BLOCK DIAGRAM 0. SATA50 BlkDiagram.p65 1/13/00, 1:54 PM 1.
— 19 — — 20 — — 18 — SA T-A55/B55 4-3. SCHEMA TIC DIAGRAMS AND PRINTED WIRING BOARDS 4-2. CIRCUIT BOARDS LOCA TION • All capacitors are in µ F unless otherwise noted. pF: µµ F 50 WV or less are not indicated except for electrolytic and tantalums.
— 22 — — 23 — — 21 — Schematic Diagram of A Board (1/4) SA T-A55/B55 A BOARD (*) MA RK LIST (1/4) S AT - A5 5 S AT - B 5 5 CN120 3P # D101 RB751V-40T E-17 # RB191 # 47 # = NO T MO UNTED 2.
— 24 — — 25 — —26 — Schematic Diagram of A Board (2/4) SA T-A55/B55 A BOARD (*) MA RK LIST (2/4) S AT - A5 5 S AT - B 5 5 Q801 2SD601A -Q # Q802 2SD601A -Q # R800 10K # R801 1K # R802 1K # # = NO T MO UNTED A BO ARD TRA NS IS TOR VO LT AG E LI ST ( 2/ 4 ) BC E Q201 2.
— 28 — — 27 — —29 — Schematic Diagram of A Board (3/4) SA T-A55/B55 A BOARD (*) MA RK LIST (3/4) S AT - A5 5 S AT - B 5 5 Q160 DTA114 EKA-T146 # # = NO T MO UNTED 4.
— 30 — — 31 — —32 — SA T-A55/B55 Schematic Diagram of A Board (4/4) A BOARD (*) MA RK LIST (4/4) S AT - A5 5 S AT - B 5 5 S AT - A5 5 S AT - B 5 5 C901 100 µ F # F B900 0 µ H# C910 0.1 µ F # IC910 IC CS492CL # C911 1 µ F # R901 10K # C912 0.
— 33 — — 34 — SA T-A55/B55 NO TE: P ortions of the circuit marked as shown are live volta ge areas. Use care to pre vent electric shocks during inspection or repair .
—36 — NO TE: P ortions of the circuit marked as shown are live volta ge areas. Use care to pre vent electric shocks during inspection or repair . — 35 — Conductor Side 1 2 3 45 A B C D E F G A.
— 37 — SA T-A55/B55 4-4. SEMICONDUCTORS 2 1 2 3 MN4SV17165BT-12 PST575DMT-T1 MN150414SA1 RD6.2MW-T1B HVU359TRF MA111 CATHODE ANODE 1 2 3 1 2 3 CATHODE ANODE 5 6 7 8 1 2 34 (TOP VIEW) NJM2129M-TE2 .
— 38 — SA T-A55/B55 7 9 1 3 14 13 10 8 15 8 2 11 12 17 16 4 5 6 SECTION 5 EXPLODED VIEWS NOTE: The components identified by shading and mark are critical for safety .
— 39 — SA T-A55/B55 4-061-591-01 BOL T , 1/4-20 UNC X 1/2 4-061-581-01 BOL T , 1/4-20 UNC X 1/2 FORMING 2 X-4035-039-2 MOUNT ASSY , REFLECTOR 3-6 3 4-061-583-01 REFLECTOR 4 4-061-584-01 REFLECTOR,.
— 40 — REF . NO. P ART NO. DESCRIPTION REMARK REF . NO. P ART NO. DESCRIPTION REMARK The components identified by shading and mark are critical for safety . Replace only with part no. specified. SA T-A55/B55 A REF . NO. P ART NO. DESCRIPTION REMARK REF .
— 41 — REF . NO. P ART NO. DESCRIPTION REMARK REF . NO. P ART NO. DESCRIPTION REMARK The components identified by shading and mark are critical for safety . Replace only with part no. specified. A SA T-A55/B55 C274 1-164-156-1 1 CERAMIC CHIP 0.1µF 25V C275 1-164-156-1 1 CERAMIC CHIP 0.
— 42 — REF . NO. P ART NO. DESCRIPTION REMARK REF . NO. P ART NO. DESCRIPTION REMARK The components identified by shading and mark are critical for safety .
— 43 — REF . NO. P ART NO. DESCRIPTION REMARK REF . NO. P ART NO. DESCRIPTION REMARK The components identified by shading and mark are critical for safety .
— 44 — REF . NO. P ART NO. DESCRIPTION REMARK REF . NO. P ART NO. DESCRIPTION REMARK The components identified by shading and mark are critical for safety .
— 45 — REF . NO. P ART NO. DESCRIPTION REMARK REF . NO. P ART NO. DESCRIPTION REMARK The components identified by shading and mark are critical for safety .
— 46 — REF . NO. P ART NO. DESCRIPTION REMARK REF . NO. P ART NO. DESCRIPTION REMARK The components identified by shading and mark are critical for safety .
— 47 — REF . NO. P ART NO. DESCRIPTION REMARK REF . NO. P ART NO. DESCRIPTION REMARK The components identified by shading and mark are critical for safety .
— 48 — SA T-A55/B55 NOTES:.
— 49 — SA T-A55/B55.
English 2000AJ74032-1 Printed in U.S.A. 2000.1 9-965-880-01 Sony Corporation Sony T echnology Center Product Quality Division Service Promotion Department.
デバイスSony SAT-B55 RM-Y139の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Sony SAT-B55 RM-Y139をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはSony SAT-B55 RM-Y139の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Sony SAT-B55 RM-Y139の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Sony SAT-B55 RM-Y139で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Sony SAT-B55 RM-Y139を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はSony SAT-B55 RM-Y139の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Sony SAT-B55 RM-Y139に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちSony SAT-B55 RM-Y139デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
