Ultra Startメーカー45xx Seriesの使用説明書/サービス説明書
ページ先へ移動 of 16
-The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle.
Page 2 This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
2WAY R EMOTE ST ARTER/ ALARM OWNER ’S GUIDE Page 3 R emote Star t - A u t o m a t i c T r a n s m i s s i o n 1. Press and release button #3. 2. The park light s will flash and the siren will chirp one time. 3. The vehicle will then remote start. The p ark light s will flash four times then remain on while the vehicle is running.
Page 4 Idle Mode 1. While the vehicle is running with key , press button #3 . 2. The park light s will turn on and the siren will chirp once. 3. T urn the ignition key off and the vehicle will continue to run. 4. Exit the vehicle and leave it running safely without leaving the keys in the Ignition.
Manual transmission remote st arters must be set into Reservation Mode before the remote st arter will activate. There are two different ways to place the system into Reservation Mode. The activation type of Reservation Mode is determined when the system is inst alled.
Page 6 1. Press and hold button #2 and the doors will unlock, continue holding button #2, the trunk release will activate. The trunk release will be confirmed by one park light flash and one siren chirp. Note: The trunk release output will not activate when the ignition key is in the “On” position.
Page 7 Car Finder is a feature that can be used to find your vehicle in a crowded parking lot. 1. Press and release button #4 twice within 3 seconds. 2. The park light s will flash and the siren will chirp five times to draw attention to the location of the vehicle.
Page 8 Auxiliary Output 1 (Optional) Sir en On/Of f Auxiliary Output 2 (Optional) Auxiliary Output are optional output s from the system. These output s Can be used to activate such things as power window roll-up/ down modules or to open and close a power sun roof.
Page 9 Cold S tart Mode will st art the vehicle at a user selectable st art interval or temperature setting. The vehicle can be set to start once every 1, 2, 3 or 4 hours in T imer Mode or to st art at 0,-5,-15 or -25 Celsius in T emperature Mode (L T Models Only) for a maximum 12 start s.
Page 10 KEY ICON- This icon will begin to flash when the remote st arter button is first pressed. Af ter the vehicle has st arted this icon will stay on solid. SIREN ICON- This icon indicates that the alarm has been triggered. The remote will st art to beep and the siren icon will come on solid at the same time as the icon for the violated zone.
Page 1 1 TIMER ICON- When this icon is displayed in the left program column if confirms that the T imer Mode has been programmed ON. When this icon is turned on in remote program mode the Cold S t art feature will be activated. Cold S t art will default to the last time or temperature setting.
Page 12 1 2 3 4 1 2 3 4 1st 2nd This feature can be used if the vehicle is p arked in an area with above average noise or vibrations. (Airport s, construction zone...) T o T emporally Byp ass The Shock Press the button #1 to arm the alarm then press button #3 within three seconds.
Page 13 1) Press and hold buttons #1 and #4 until the minute portion of the clock begins to flash. 2) T o set the minute, press button #3 to increase and button #2 to decrease the minute. 3) T o set the hour , press button #1 and the hour portion of the clock will begin to flash.
Page 14 A TTENTION: T O A VOID SERIOUS INJUR Y , this remote st art system must be set into Service Mode before any under hood servicing is st arted. Service Mode will prevent the vehicle from st arting while the vehicle is being serviced. It is the sole responsibility of the vehicle’ s owner to place the system into Service Mode.
Page 15 Being that the installer does not always see when the system shut s down or fails to start, Diagnostic Memory will store in memory up to four shut down codes. This information can then be accessed to determine the source of the shut down. T o Enter Diagnostic Mode: St ep 1 - T urn the ignition on then off.
Limited Lif etime W ar r anty The manufacturer warrants to the original purchaser of their remote starters and alarms, that the product shall be free from defects in material and workmanship.
デバイスUltra Start 45xx Seriesの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Ultra Start 45xx Seriesをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはUltra Start 45xx Seriesの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Ultra Start 45xx Seriesの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Ultra Start 45xx Seriesで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Ultra Start 45xx Seriesを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はUltra Start 45xx Seriesの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Ultra Start 45xx Seriesに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちUltra Start 45xx Seriesデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
