Vulcan-HartメーカーVL3GSS ML-52393の使用説明書/サービス説明書
ページ先へ移動 of 16
VULCAN-HART P.O. BOX 696, LOUISVILLE, KY 40201-0696 DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC TEL. (502) 778-2791 WWW.VULCANHART.COM FORM 35409 Rev. A (Aug. 2004) INST ALLA TION & OPERA TION MANUAL Model VL2GSS For additional information on Vulcan-Hart or to locate an authorized parts and service provider in your area, visit our website at www.
– 2 – IMPORT ANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS DETECTED.
– 3 – T ABLE OF CONTENTS GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
– 4 – Installation, Operation and Care of VL2 & VL3 GAS FOOD STEAMERS SA VE THESE INSTRUCTIONS FOR FUTURE USE GENERAL Vulcan-Hart suggests that you thoroughly read this entire manual and carefully follow all of the instructions provided. Your Vulcan Model VL Food Steamer is produced with quality workmanship and materials.
– 5 – INSTALLATION CODES AND STANDARDS In the United States, the Vulcan steamer must be installed in accordance with state and local codes, with the National Fuel Gas Code, (ANSI-Z223.1, latest edition) available from the American Gas Association, 1515 Wilson Boulevard, Arlington, VA 22209, with the National Electrical Code (ANSI/ NFPA No.
– 6 – PLUMBING CONNECTIONS WARNING: PLUMBING CONNECTIONS MUST COMPLY WITH APPLICABLE SANITARY, SAFETY AND PLUMBING CODES. Water Requirements Proper water quality can improve the taste of the food prepared in the steamer, reduce liming in the steam generator and extend equipment life.
– 7 – GAS CONNECTION CAUTION : All gas supply connections and any pipe joint compound used must be resistant to the action of liquefied petroleum gases. Codes require that a gas shutoff valve be installed in the gas line ahead of the steamer. Connect the gas supply line to the gas valve on the steamer.
– 8 – INSTALLATION DRAWING Models VL2GSS & VL3GSS Fig. 3 LEGEND GAS CONNECTION: 3 / 4 " NPT BOILER FEED CONNECTION FOR FILTERED WATER: 1 / 4 " NPT WATER CONNECTION FOR BOILER DRAIN CONDENSER: 1 / 4 " NPT ELECTRICAL CONNECTION: 120 V, 60 HZ, 1 PH, 300 WATTS MAX DRAIN: 3 1 / 2 " DIA.
– 9 – DRAIN REQUIREMENTS The floor sink is not to be located under the steamer. Fig. 4.
– 10 – IGNITION SWITCH RESET BOILER ON - OFF HI LIMIT PRESSURE LOW WATER DISCONNECT POWER BEFORE REMOVING THIS OR ANY PANEL GIVING ACCESS TO PARTS. BOILER OPERATING INSTRUCTIONS 1) KEEP BOTH WATER GAUGE VALVES OPEN AT ALL TIMES 2) BE SURE WATER INLET VALVE IS OPEN.
– 11 – AUTOMA TIC BLOW DOWN V AL VE GAS COMBINA TION V AL VE OPTIONAL MANUAL BLOW DOWN V AL VE Fig. 7.
– 12 – STEAM COOKING — COMPARTMENT OPERATION Refer to the Steam Cooking with Vulcan Kettles and Steamers (booklet packed with your steamer) for suggested cooking times of various foods. All cooking times are approximate because size, weight, pan loading and product quality will affect steamer cooking times.
– 13 – SELECTION OF PANS FOR STEAM COOKING VL steamer compartments are designed to accept combinations of the following perforated or solid cooking pans (Fig. 8): PAN ACCOMODATION, PER COMPARTMENT Max Qty Pan Size Pan Depth 4 12 X 20 6 6 12 X 20 4 8 12 X 20 2 1 / 2 6 18 X 26 (center support removed) 1 16 12 x 20 1 Fig.
– 14 – Separate frozen food packs into smaller chunks. If unpacked pre-cooked frozen dishes require more than 15 minutes to cook, cover the pan. When a cover is used, about one-third more cooking time is required.
– 15 – DOOR GASKETS Clean the gasket sealing surface of the compartment doors to remove harmful food acids for maximum gasket life. Do not use any solvents. Wash with a cloth moistened in a solution of mild detergent and warm water. Rinse with a fresh cloth moistened with warm water to remove all traces of detergent.
– 16 – WATER LEVEL GAUGE Check the water level gauge sight glass daily. The correct water level is approximately 1" ( 2.5 cm ) of water visible in the water level gauge sight glass. Extremely murky water in the sight glass indicates bad water conditions.
デバイスVulcan-Hart VL3GSS ML-52393の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Vulcan-Hart VL3GSS ML-52393をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはVulcan-Hart VL3GSS ML-52393の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Vulcan-Hart VL3GSS ML-52393の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Vulcan-Hart VL3GSS ML-52393で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Vulcan-Hart VL3GSS ML-52393を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はVulcan-Hart VL3GSS ML-52393の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Vulcan-Hart VL3GSS ML-52393に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちVulcan-Hart VL3GSS ML-52393デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。