Vulcan-HartメーカーVPX5 126588の使用説明書/サービス説明書
ページ先へ移動 of 20
A product of VULCAN-HART LOUISVILLE, KY 40201-0696 F25111 (March 2002) - NOTICE - This Manual is prep ared for the use of trai ned Vulcan Servi c e Te ch nic ia ns and should not be us ed by those not properly qua li fied.
VPX SERIES STEAMERS F25111 (March 2002) Page 2 of 20 TABLE OF CONTENTS G E N E R A L ................................................................................ 3 Installation, O peration and Cleaning .............................................
VPX SERIES STEAMERS - GENERAL F25111 (March 2002) Page 3 of 20 GENERAL INSTA LLA T I ON, OPERA TION A ND CLEANING Refer to the Inst allat ion & Operation Manual for specific instructions.
VPX SERIES STEAMERS - REMOVAL AND REPLACEM ENT OF PART S F25111 (March 2002) Page 4 of 20 REMOVAL AND REPLACEMENT OF PARTS COVERS A ND PA NELS WA RNING: DISCONNECT THE ELECTR ICAL POW ER TO TH E MACHINE AT THE MAIN CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT BOX INDICATI NG THE CIRCUIT IS BEING SERVICED.
VPX SERIES STEAMERS - REMOVAL AND REPLACEM ENT OF PART S F25111 (March 2002) Page 5 of 20 4. Reverse procedure to install replacement component and check steamer for proper operation.
VPX SERIES STEAMERS - REMOVAL AND REPLACEM ENT OF PART S F25111 (March 2002) Page 6 of 20 NOTE: Thermostat base is a brass 5/8" hex with a threaded stem. 4. Apply a small amount of "thermal transfer compound" to the mating surface (disk side) of the replacement thermostat.
VPX SERIES STEAMERS - REMOVAL AND REPLACEM ENT OF PART S F25111 (March 2002) Page 7 of 20 5. Remove mounting nuts & washers from the rear cooking compartment support legs and remov e base. 6. Disconnect heating element lead wires from element terminals.
VPX SERIES STEAMERS - REMOVAL AND REPLACEM ENT OF PART S F25111 (March 2002) Page 8 of 20 A. Temporarily install a flat washer and nut on all mounting studs. Hand tighten only . B. Tighten each nut to 100 in-lb using t he sequence as shown. C. Remove nut and washer from each mounting stud.
VPX SERIES STEAMERS - REMOVAL AND REPLACEM ENT OF PART S F25111 (March 2002) Page 9 of 20 5. Remove mounting nuts & washers from the rear cooking compartment support legs and remov e base. 6. Remove outer nut on drain valve stem and lift off drain handle assembly.
VPX SERIES STEAMERS - REMOVAL AND REPLACEM ENT OF PART S F25111 (March 2002) Page 10 of 20 Gasket 1. Open the door. 2. Remove screws from the gask et plate. 3. Pull the gasket plate out from the door housing and remove the gasket. 4. Position the new gasket on t he gasket plat e and reverse the procedure to install.
VPX SERIES STEAMER - SERVICE PROCEDURES AND ADJUSTM ENTS F25111 (March 2002) Page 11 of 20 Latch A ssembly 1. Open the door. 2. Remove screws from the top and bottom of the door. 3. Pull the "inner" door panel out from the door housing with the gasket plate and gasket st ill attached.
VPX SERIES STEAMER - SERVICE PROCEDURES AND ADJUSTM ENTS F25111 (March 2002) Page 12 of 20 To adj u st : 1. Reinstall the st riker with t he slot pointing upwards and "hand tighten" nut only . 2. Close the door to cent er t he st rik er in the oval mounting hole.
VPX SERIES STEAMER - SERVICE PROCEDURES AND ADJUSTM ENTS F25111 (March 2002) Page 13 of 20 VOLTAG E KW PER ELEMENT AMPS PER ELEMENT OHMS PER ELEMENT 1 PH 3 PH 208 3 14.4 8.3 14.4 240 3 12.5 7.2 19.2 480 3 3.6 76.8 208 5 24.0 14.0 8.70 240 5 21.0 12.0 11.
VPX SERIES STEAMER - ELECTRICAL OPERATION F25111 (March 2002) Page 14 of 20 ELECTRICAL OPERATION COMP ONENT FUNCTI ON B u z z e r .................. Signals end of a "cook" cycle when cooking time expires. C o n t a c t o r ............... Supplies line v oltage to heat ing elem ent assembly.
VPX SERIES STEAMER - ELECTRICAL OPERATION F25111 (March 2002) Page 15 of 20 SEQUENCE OF OPERA TION W iring diagram 7264 will be used to explain the electrical sequence of operation. Time d Cooking Mode 1. Conditions. A. Steamer connected to correct voltage and is properly grounded.
VPX SERIES STEAMER - ELECTRICAL OPERATION F25111 (March 2002) Page 16 of 20 F. Door closed (door switch closed). G. Timer "off". H. Cooking compartment filled to the water level mark and below standby t em perature of 168 ° F (+5/-8). 2. Select "continuous" on the cooking mode switch.
VPX SERIES STEAMER - ELECTRICAL OPERATION F25111 (March 2002) Page 17 of 20 WIRING DI A GRAMS 208-240V.
VPX SERIES STEAMER - ELECTRICAL OPERATION F25111 (March 2002) Page 18 of 20 480V.
VPX SERIES STEAMER - TROUBLESHOOTING F25111 (March 2002) Page 19 of 20 TROUBLESHOOTING WA RNING: CERTAIN PROCEDURES IN THIS SECTION REQUIRE ELECT RICAL TESTS OR MEASUREMENTS W HILE POW ER IS APPLIED TO THE MACHINE. EXERCISE EXTREME CAUTION AT ALL TIMES.
VPX SERIES STEAMER - CONDENSED SPARE PARTS LIST F25111 (March 2002) Printed in U.S.A. CONDENSED SPARE PARTS LIST VPX3 & VPX5 PART NUMBER DESCRIPTION NOTES 844385 Door Gasket (VPX5) 844196 Door Gas.
デバイスVulcan-Hart VPX5 126588の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Vulcan-Hart VPX5 126588をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはVulcan-Hart VPX5 126588の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Vulcan-Hart VPX5 126588の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Vulcan-Hart VPX5 126588で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Vulcan-Hart VPX5 126588を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はVulcan-Hart VPX5 126588の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Vulcan-Hart VPX5 126588に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちVulcan-Hart VPX5 126588デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
