C. CraneメーカーTwin Coil Ferriteの使用説明書/サービス説明書
ページ先へ移動 of 16
T win C oil F errit e ™ PLEASE READ ALL THE INSTRUCTIONS COMPLETEL Y BEFORE USE AND SA VE THIS MANU AL FOR FUTURE REFERENCE. AM A nt enna By Operating Instructions.
25 ft. Remote Installation Kit Optional Accessories: Cable Coupler For Use With Cables 75 ft. in Length 50 ft. Remote Installation Kit Kits include 25 ft. or 50 ft. of PS2 cable, connector grease and coax seal. Bef ore Use Please read IMPOR T ANT SAFETY INSTR UCTIONS on pages 13 - 14 bef ore use .
P ar ts List ........................................................................... 4 Battery Installation ........................................................... 4 Connection to P ower ........................................................
1) TUNER CONTROL 2) ANTENNA ELEMENT 3) FERRITE STICK 4) 1/8" Mono to RCA Connector Patchcord 5) RCA Female Patchcord to T wo Bare Wire Ends Remove the battery compartment cover on the bottom of the TUNER CONTROL. Connect the battery . The antenna will run for approximately 45 hours on battery power .
These instructions cover the basic setup. Attach one end of the 5' PS2 cable to the jack, labeled T o Antenna , on the back of the TUNER CONTROL unit. The arrow on the plug should face up. Please, DO NO T force the plug into the TUNER CONTROL. It will plug in nicely when the pins are aligned.
The first time you use the T win Coil Ferrite AM Antenna by C. Crane it takes time, planning, and a little bit of patience. Y ou will need to re-check and re-tune the unit to find the best position.
Place the TUNER CONTROL in a comfortable location relative to your radio. Place the ANTENNA ELEMENT a few feet away . If the ANTENNA ELEMENT is placed too close to the radio, it will cause noise on your radio. 1. Put the FERRITE STICK on top of the radio near the center .
Y ou can directly connect the T win Coil Ferrite AM Antenna by C. Crane to a home stereo by connecting the 1/8" Mono x RCA con- trol patchcord to the RCA x two wire patchcord, as shown below left. Y ou can then attach one wire to the GROUND and one wire to the AM terminal on the back of the receiver , as shown below right.
If after thorough testing, you find the ANTENNA ELEMENT must be mounted outdoors for best reception, you may order additional cable in 25' or 50' lengths (refer to the inside cover for optional accessories). Generally , you will only need to mount the antenna outdoors if radio noise and static reduce reception indoors.
Lightning poses a serious hazard to you and to your radio equipment. Y our antenna is a conductor . If it is struck by lightning (or touched by a live power line), it will conduct this electricity into your home. Safety precautions require that you equip your antenna with lightning protection equipment.
If radio noise is present, many times grounding the ANTENNA ELEMENT will reduce it significantly . It is not necessary to ground the antenna if there is no radio noise. The easiest way to ground the ANTENNA ELEMENT is to place a #10 solid copper wire three or four feet into the ground.
P age 12 T win Coil Ferrite ™ AM Antenna by C. Crane Radio Noise T r oubleshooting AM RADIO NOISE PROBLEMS AND POSSIBLE SOLUTIONS If you hear an annoying buzz when listening to AM radio, it’s most likely radio noise. Here are some of the usual culprits: • Dimmer switch (even in an adjacent room).
T win Coil Ferrite ™ AM Antenna by C. Crane P age 13 READ BEFORE OPERA TING EQUIPMENT SA VE THESE INSTRUCTIONS 1) Read and understand all safety and operating instructions before the T win Coil Ferrite AM Antenna by C. Crane is operated. 2) Retain Instructions: The safety and operating instructions should be retained for future reference.
P age 14 T win Coil Ferrite ™ AM Antenna by C. Crane 10) If the antenna is stored for long periods of time, unplug it from the wall outlet and remove the batteries. This will prevent damage caused by lightning or power line surges and battery acid from leaking inside of the antenna.
T win Coil Ferrite ™ AM Antenna by C. Crane P age 15 City Frequency Date T ime P ERSONAL S T A TION L OG Station Call Letters Please feel free to copy this page.
Model: TWIN COIL FERRITE ™ AM ANTENNA BY C. CRANE THIS DEVICE COMPLIES WITH P ART 15 OF THE FCC RULES. OPERA TION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS. 1) THIS DEVICE MA Y NOT CAUSE HARMFUL INTERFERENCE, AND 2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THA T MA Y CAUSE UNDESIRED OPERA TION.
デバイスC. Crane Twin Coil Ferriteの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
C. Crane Twin Coil Ferriteをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはC. Crane Twin Coil Ferriteの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。C. Crane Twin Coil Ferriteの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。C. Crane Twin Coil Ferriteで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
C. Crane Twin Coil Ferriteを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はC. Crane Twin Coil Ferriteの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、C. Crane Twin Coil Ferriteに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちC. Crane Twin Coil Ferriteデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。