MieleメーカーS 360の使用説明書/サービス説明書
ページ先へ移動 of 36
Operating instructions Vacuum cleaners S 360 - S 388 To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before using it for the first time.
Caring for the environment Description of the appliance Warning and Safety instructions Preparing for use Accessories supplied Using the accessories Floorhead . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Disposal of packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic, wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children.
Some models are supplied with a Miele Electrobrush or Turbobrush as standard (not illustrated). These brushes are supplied with their own operating instructions.
a Mains cable with plug (plug varies depending on country) b Park system c Cable rewind d Suction power selector * e Overheating warning light * f On / Off switch g Exhaust filter * h Dustbag change i.
This vacuum cleaner meets statutory safety requirements. Improper use can, however, lead to personal injury and material damage. To avoid the risk of accidents and damage to the vacuum cleaner, read these instructions carefully before using it for the first time.
~ There is a metal inlay underneath the handle which is designed to avoid the unpleasant effects of electrostatic discharges. Please make sure that you keep your hand in constant contact with this metal strip during vacuuming.
~ Do not vacuum up any inflammable or combustible liquids or gases and do not vacuum in areas where such substances are stored. The cleaner might explode. ~ Do not vacuum up items which are heavy, hard or have sharp edges. They could cause a blockage and damage the appliance.
Attaching the suction hose ^ Insert the hose connector into the suction socket until it clicks into position. To remove the suction hose from the cleaner ^ Press the release buttons at the side of the hose connector and lift the hose from the socket.
Connecting the suction tube sections (depending on model) Both sections of the suction tube have locating arrows marked on them. When connecting the two sections, ensure that the two arrows point towards each other.
Attaching the floorhead ^ Push the suction tube into the floorhead and turn it clockwise or anti-clockwise until it clicks into position. ^ To release the floorhead from the suction tube, press the locking button (see arrow) and pull the suction tube away from the floorhead.
Other tools, in addition to the floorhead(s), are supplied with the vacuum cleaner to help deal with various types of cleaning. - Crevice nozzle - Dusting brush - Upholstery nozzle These tools are stored in the special compartment in the vacuum cleaner and can be put back after use.
The different tools can either be fitted to the hand-piece or, as required, to the suction tube. Floorhead For general use and also for cleaning stairs. For safety reasons when vacuuming stairs it is best to start at the bottom of the stairs and move upwards.
Dusting brush For cleaning skirting boards, ornate or carved articles, etc. The head of the dusting brush can be swivelled to attain the best cleaning position.
Unwinding and rewinding the mains cable Unwinding ^ Hold the plug and unwind cable to the required length (max. approx. 5.5 metres). Warning: If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Otherwise there is a danger of overheating and damage.
Switching on and off ^ Press the On-Off switch. Vacuuming ^ When vacuuming pull the cleaner behind you on its wheels. You can stand it upright for vacuuming stairs and curtains etc. Warning: When vacuuming especially fine dust, e.g. sawdust, sand, plaster, flour, talcum powder etc.
Regulating the suction (for models with a rotary suction power selector) The suction power can be regulated to suit the type of flooring. The higher the setting the more powerful the suction. Reducing the suction power reduces the amount of effort required to manoeuvre the floorhead.
Park system A Park system has been designed for conveniently parking the vacuum cleaner during pauses. ^ Fit the floorhead into the parking attachment at the back the vacuum cleaner. Transportation and storage ^ Stand the vacuum cleaner upright when it is not being used and during storage.
Dustbag change indicator Change the dustbag when the colour marker in the dustbag change indicator fills the display. Dustbags are designed for single use only. Do not attempt to re-use them as suction would be reduced. Checking the dustbag change indicator ^ Attach the standard floorhead to the suction tube.
Warning: Always disconnect the vacuum cleaner from the electrical supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug.
ACTIVE air clean filter If your vacuum cleaner is fitted with an ACTIVE air clean filter and you wish to go on using this type of filter make sure that you purchase a replacement in good time. The ACTIVE air clean filter is a special active charcoal filter which contains charcoal to absorb odours from the dust collected in the dustbag.
Dust compartment filter (for motor protection) Replace the dust compartment filter every time you start a new packet of Miele dustbags. A dust compartment filter is supplied with every packet of Miele dustbags.
To replace the dustbag and filters Open the dust compartment lid ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. To replace the dustbag ^ To remove the dustbag hold the bag by the collar and pull it out of its holder.
Do not use more than one exhaust filter at a time. Replacing the SUPER air clean filter ^ Open the dust compartment lid. ^ Unclip the filter frame and raise it upwards. ^ Take hold of the used SUPER air clean filter by the clean, unsoiled section (see arrow) and take it out.
Dust compartment filter (for motor protection) ^ Open the dust compartment lid. ^ Unclip the filter frame, remove the old filter and replace with a new one. ^ Close the filter frame. Changing the thread lifters The thread lifters on the suction inlet to the floorhead and upholstery nozzle can be replaced.
Warning: Always disconnect the vacuum cleaner from the electrical supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug (pull on the plug, not the cable). If using the ACCU NOVA floorhead, switch this off as well.
The vacuum cleaner has switched itself off automatically A temperature limiter switches the vacuum cleaner off automatically if it gets too hot. Some models also have an overheating warning light , which comes on to let you know that your cleaner has overheated.
Miele accessories including floorheads, filters and dustbags are available to order from your Dealer, the Miele Spare Parts Department or via the internet on www.
Hard floor brush This brush is designed for use on hard flooring such as tiled or stone floors. Parquet floor brush This brush has natural bristles and is designed for use on parquet floors and other surfaces which are susceptible to scratching such as laminate floor.
Dusting brush with natural bristles This brush is suitable for particularly delicate objects. Radiator brush For cleaning radiators, narrow shelves and crevices. ^ Attach the radiator brush to the crevice nozzle. Crevice nozzle (300 mm) For cleaning in folds, crevices or corners.
Mattress nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. Universal brush For dusting books, shelves, etc. MicroSet This set is specially designed for cleaning small objects and difficult to reach areas (such as PC keyboards, stereo equipment, intricately carved furniture and ornaments, models etc).
CarClean Set Plus The CarClean Set Plus has been designed as an accessory for Miele cylinder vacuum cleaners for valeting the interior of cars. It consists of: – Hand-held Turbobrush – Micro-hose .
ACTIVE air clean filter The ACTIVE air clean filter is a special active charcoal filter which absorbs odours from the dust collected in the dustbag. It helps to prevent the build-up of odours. Do not use aroma capsules in your cleaner if you use this filter.
All electrical work should be carried out by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). The voltage and connected load are given on the data plate located underneath the vacuum cleaner.
35.
M.-Nr. 07 276 450 / 00 Alteration rights reseved / (S 360 - S 388) - 0408.
デバイスMiele S 360の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Miele S 360をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMiele S 360の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Miele S 360の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Miele S 360で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Miele S 360を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMiele S 360の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Miele S 360に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMiele S 360デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
