MieleメーカーS 700 seriesの使用説明書/サービス説明書
ページ先へ移動 of 36
Operating instructions Vacuum cleaners S 700 series To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before using it for the first time. These operating instructions apply to standard models S 71 0-S7 1 8 and to Special Edition models which are distinguished by names rather than model numbers.
Caring for the environment Description of the appliance Warning and Safety instructions Preparing for use Accessories supplied Using the accessories supplied Use Mains cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Disposal of packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic, wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children.
Description of the appliance 4.
a Hand piece b Air inlet valve c Release button d Telescopic suction tube * e Telescopic tube release button * f Dust compartment release button g Dust compartment filter (for motor protection) h Dust.
This vacuum cleaner meets statutory safety requirements. Improper use can, however, lead to personal injury and material damage. To avoid the risk of accidents and damage to the vacuum cleaner, read these instructions carefully before using it for the first time.
Technical safety ~ Ensure that the connection data on the data plate (voltage and frequency) match the mains electricity supply. It is essential that they match to avoid damage to the appliance. ~ The plug must be fitted with a 13 A fuse (UK). ~ Before using the vacuum cleaner, check for any signs of damage.
Correct use ~ To avoid the risk of damage, do not use the vacuum cleaner without the dustbag, dust compartment filter and exhaust filter in place. Otherwise it could get damaged. ~ If a dustbag is not inserted, the dust compartment cover does not normally close.
Accessories Miele accessories including floorheads, filters and dustbags are available to order from your Miele retailer, the Miele Spare Parts Department or via the internet on www.miele-shop.com. ~ To avoid the risk of injury when vacuuming with a Miele Electrobrush or Turbobrush, do not touch the rotating roller brush.
Attaching the suction hose ^ Insert the hose connector into the socket until it clicks into position. Removing the suction hose from the cleaner ^ Press the release buttons at the side of the hose connector, and lift the hose from the socket.
Your vacuum cleaner is fitted with one of the following suction tubes, depending on model: – Connecting tubes – 2-part telescopic tube Connecting the suction tube sections Both sections of the suction tube have locating arrows marked on them. When connecting the two sections, ensure that the two arrows point towards each other.
Fitting the standard floorhead ^ Push the suction tube into the floorhead and turn it clockwise or anti-clockwise until it clicks into position. ^ To release the floorhead from the suction tube, press the locking button (see arrow) and pull the suction tube away from the floorhead.
Other tools, in addition to the floorhead(s), are supplied with the vacuum cleaner to help deal with various types of cleaning. a Crevice nozzle b Dusting brush c Upholstery nozzle Taking the accessories out ^ Press the release button to open the accessories compartment lid.
The different tools can either be fitted to the hand piece or to the suction tube, as required. Standard floorhead For general use and also for vacuuming stairs. For safety reasons when vacuuming stairs it is best to start at the bottom of the stairs and move upwards.
Dusting brush For cleaning skirting boards, ornate or carved articles, etc. The head of the dusting brush can be swivelled to attain the best cleaning position.
Mains cable Unwinding the cable ^ Pull out the mains cable to the required length (max. approx. 6.5 m). Warning: If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Otherwise there is a danger of overheating and damage.
Adjusting the suction power The suction power can be regulated to suit the type of flooring. The higher the wattage, the more powerful the suction. Reducing the suction power reduces the amount of effort required to manoeuvre the floorhead.
Parking system A parking system has been designed for conveniently parking the vacuum cleaner during pauses. ^ Slot the floorhead into the parking attachment at the back of the vacuum cleaner. Transportation and storage ^ Stand the vacuum cleaner upright when it is not being used and during storage.
Warning: Always disconnect the vacuum cleaner from the electrical supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug.
When to change the dustbag Change the dustbag when the colour marker in the dustbag change indicator fills the display, or sooner if it is no longer effective (see possible reasons for this below). Miele dustbags are disposable, and designed for single use only.
Replacing the dustbag ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. ^ To remove the dustbag, hold the bag by the collar and pull it out of its holder. The dustbag has a closing flap which closes automatically when the dustbag is removed to prevent any dust escaping.
When to change the exhaust filter Depending on the model, your vacuum cleaner will be fitted as standard with one of the following exhaust filters: a a Super Air Clean filter, Replace this filter every time you start a new packet of Miele dustbags.
Replacing the Super Air Clean filter Do not use more than one exhaust filter at a time. ^ Open the dust compartment lid. ^ Release the filter grille and raise it upwards. Grasp the used Super Air Clean filter by the clean, unsoiled section (see arrow) and take it out.
Replacing an Active Air Clean filter or an Active HEPA filter Do not use more than one exhaust filter at a time. ^ Open the dust compartment lid. ^ Release the catch and remove the filter. ^ To insert the new filter, fit it so that it engages at the back and then close the catch.
When to change the dust compartment filter (for motor protection) Replace this filter every time you start a new packet of dustbags. A dust compartment filter is supplied with every packet of Miele dustbags. How to change the dust compartment filter ^ Open the dust compartment lid.
When to change the thread lifters The thread lifters on the suction inlet to the floorhead and the upholstery nozzle can be replaced. Check them from time to time and replace them if the pile has worn down. To replace the thread lifters ^ Use a knife or similar object to remove them from the slots.
Warning: Always disconnect the vacuum cleaner from the electricity supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug.
The vacuum cleaner switches off automatically. A temperature limiter switches the vacuum cleaner off automatically if it gets too hot. This can occur if, for instance, large articles block the suction tube or when the filter bag is full or contains particles of fine dust.
Miele accessories including floorheads, filters and dustbags are available to order from your local Miele retailer, the Miele Spare Parts Department or via the internet on www.
ALLERGOTEC -3 floorhead The level of cleanliness of the floor shows in a colour "traffic light" display when vacuuming. The ALLERGOTEC floorhead is designed specially for the daily hygienic cleaning of all floor surfaces. Hard floor brush -3 This brush is designed for use on hard flooring such as tiled or stone floors.
Universal brush For dusting books, shelves, etc. Dusting brush with natural bristles This brush is suitable for particularly delicate objects. Radiator brush (Can only be used if attached to the crevice nozzle). For cleaning radiators, narrow shelves and crevices.
Mattress nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. Crevice nozzle (300 mm) For cleaning in folds, crevices or corners. Hose adapter For extending the suction hose by approx. 1.5 m. The adapter is fitted between the hand piece and the suction hose.
Hygiene seal with active charcoal This prevents dust and odours from escaping when the suction hose is removed for transportation or storage. It can be secured to the suction hose during vacuuming.
Active Air Clean filter A special active charcoal filter, which removes odours coming from the dirt in the dustbag, keeping unpleasant lingering smells to a minimum.
All electrical work should be carried out by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). The voltage and connected load are given on the data plate located underneath the vacuum cleaner.
Alteration rights reserved / (710-718) - 1508 M.-Nr. 07 316 630 / 00.
デバイスMiele S 700 seriesの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Miele S 700 seriesをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMiele S 700 seriesの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Miele S 700 seriesの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Miele S 700 seriesで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Miele S 700 seriesを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMiele S 700 seriesの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Miele S 700 seriesに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMiele S 700 seriesデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
