MieleメーカーS184の使用説明書/サービス説明書
ページ先へ移動 of 12
Operating Instructions V acuum Cleaner S183, S184 Please carefully study these Operating Instructions before attempting to operate the unit and note the listed Important Safety Instructions.
2 When using this vacuum cleaner, basic precautions should always be followed , including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER W ARNING To reduce the risk of fire, electric shock, or injury: • Do not leave vacuum cleaner unattended when it is plugged in.
3 IDENTIFICA TION OF MAIN P AR TS A-1) Handle H) Bag change indicator B-2) Cord clip C) ON/OFF Switch Dust bag cover E) Foot pedal F) Beater bar selector Carry handle J) Exhaust cover HEPA filter Bump.
A) HANDLE ASSEMBL Y 4 C) ON / OFF SWITCH To start or stop the vacuum cleaner, push the switch to “I” to turn it ON , and to “ O ” to turn it OFF . B) POWER CORD STORAGE NOTE: To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other).
5 E) USING THE FOOT PEDAL TO ADJUST THE V ACUUM HEIGHT To lower the body of the cleaner, step on the pedal at the left rear corner of the vacuum cleaner. D) V ARIABLE POWER CONTROL (S184 Only) 1. Upright position The handle should be in an upright position when cleaning tools are used.
6 F) BEA TER BAR SELECTOR When cleaning carpeted floor, slide the selector to the “ BEATER BAR ” position. To stop the beater bar while using accessories, slide the selector to the “ STOP ” position. NOTE: The vacuum cleaner should be running when changing the position of the BEATER BAR SELECTOR.
7 I) REPLACING THE DUST BAG H) BAG CHANGE INDICA TOR CAUTION: DISCONNECT THE CLEANER FROM THE OUTLET BEFORE PERFORMING THE OPERA TIONS BELOW The bag change indicator located on the front of your cleaner normally indicates when the dust bag should be changed.
8 J) CHANGING FIL TERS TROUBLE SHOOTING GUIDE Before r eturning the vacuum cleaner to a Miele Service Center , check the following items: Problem Check Point Cause / Remedy Motor doesn ’ t run. (no noise is heard at all) Motor runs but no suction. Beater bar does not rotate.
9 MAINTENANCE FOR THE BEA TER BAR BLOCKAGES If your cleaner stops picking up dust, or the Bag Change Indicator shows "Full" while the dust bag is still empty, a blockage may have occurred. To remove the obstruction, proceed as follow: Remove the hose from the suction inlet by turning the hose to the right and pulling it out (Fig.
10 SERVICING AND REP AIRS Use only genuine Miele replacement parts. DISCONNECT THE CLEANER FROM THE ELECTRICAL SUPPLY If you have any questions, contact your local dealer / service agent. Any service needed other than that described in these Operating Instructions should be performed by a Miele Service Center, only.
T o avoid damaging the power cord, never run over the cord or allow it to become caught in the beater bar when using the vacuum cleaner . STORING THE APPLIANCE 11 CORD CARE Hold any excess cord in your fr ee hand while vacuuming in order to avoid running over the cord.
National Headquarters MIELE, INC. 9 INDEPENDENCE WAY PRINCETON, NJ 08540 Phone: (609) 419-9898 or (800) 843-7231 Fax: (609) 419-4298 www.miele.com Showroom Locations National Headquarters Miele, Inc. 9 Independence Way Princeton, NJ 08540 Phone: (609) 419-9898 Fax: (609) 419-4298 Southwest Miele, Inc.
デバイスMiele S184の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Miele S184をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMiele S184の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Miele S184の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Miele S184で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Miele S184を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMiele S184の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Miele S184に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMiele S184デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。