United States StoveメーカーVFZC32Nの使用説明書/サービス説明書
ページ先へ移動 of 32
C O M P A N Y U N I T E D S T A T E S S T O V E C S S U Models VFZC32N, VFZC32L V ent-Free Zero-Clearance Gas Fireplace United States Stove Company 851301 3/98 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life.
2 TABLE OF CONTENTS IMPORTANT: Read this owner's manual carefully and completely before trying to assemble, operate, or service this fireplace. Improper use of this fireplace can cause serious injury or death from burns, fire, explosion, electrical shock, and carbon poi- soning.
WARNING: Any change to this heater or its controls can be dangerous. 1. This heater shall not be installed in a bedroom or bathroom. 2. Never install the fireplace * in a recreational vehicle * where .
4 WARNINGS/SAFETY INFORMATION CONTINUED 17. CARBON MONOXIDE POISONING: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nausea. If you have these signs, obtain fresh air immediately. Have the heater serviced as it may not be operating properly.
5 VFZC32 SPECIFICATIONS, CONTINUED... FIREBOX TOP VIEW FIREBOX FRONT VIEW FIREBOX SIDE VIEW.
6 PRODUCT FEATURES AIR FOR COMBUSTION AND VENTILATION This fireplace shall not be installed in a confined space unless provisions are provided for adequate combustion and ventilation air. Read the following instructions to insure proper fresh air for this and other fuel-burning appliances in your home.
7 AIR FOR COMBUSTION AND VENTILATION CONTINUED Providing adequate ventilation The following is excerpts from National Fuel Gas Code. NFPA 54/ANSI Z223.1, Section 5.3, Air for Combustion and Ventilation. All spaces in homes fall into one of the three following ventilation classifications: 1.
8 AIR FOR COMBUSTION AND VENTILATION CONTINUED Determining if You Have a Confined or Unconfined Space Use this worksheet to determine if you have a confined or unconfined space. Space: Includes the room in which you will install the firebox plus any adjoining rooms with doorless passageways or ventilation grills between the rooms.
9 AIR FOR COMBUSTION AND VENTILATION CONTINUED B. Vent room directly to the outdoors. See Ventilation Air from Outdoors , page 10. C. Install a lower BTU/Hr firebox, if lower BTU/Hr size makes room unconfined. If the actual BTU/Hr used is less than the maximum BTU/Hr the space can support, the space is an unconfined space.
10 AIR FOR COMBUSTION AND VENTILATION CONTINUED Ventilation Air From Outdoors Provide extra fresh air by using ventilation grills or ducts. You must provide two permanent openings: one within 12" of the ceiling and one within 12" of the floor.
11 INSTALLATION CONTINUED 42" NOTE: CLEARANCES ARE THE SAME IF USING OPTIONAL CABINET MANTELS OR BUILT-IN INSTALLATION. Figure 3 - Minimum Clearance to Wall and Ceiling Mantel Clearances for Buil.
12 INSTALLATION CONTINUED Installing the Fireplace Screen. 1. Insert each rod through the rings located at the top of the screen. NOTE: Before placing the last ring over the rod, slide the tinnerman clip (included in the parts bag) onto the rod and then slide the last ring over the rod.
13 INSTALLATION CONTINUED 1. Before installing the firebrick panels you must first remove the brick brackets. A 5/16" nut driver will be required. ( See Figure 7a & b, below for location ) 2. Carefully remove the firebrick panels from their box.
GAS CONNECTION CAUTION Use new black iron or steel pipe only. Internally tinned copper tubing can be used in some areas when permitted by local codes. Only use pipe of 1/2" or greater diameter to allow full gas volume to heater. Excessive pressure loss will occur if the pipe is too small.
Control Valve Control Bracket (Rightside view facing heater) Test Pressure Input Test Pressure Output GAS CONNECTION, CONTINUED... GAS PRESSURE CHECK 15 The gas inlet connection is 3/8" NPT, made at the rear of the main control. This unit comes with an 18" gas flex pipe attached to the control valve at the factory.
MANTEL INSTALLATION This fireplace may be installed using the cabinet mantel with hearth base accessory against a wall in your home. You must use one of the Satin Black or Polished BrassTrim Kits available when installing your fireplace with the optional mantel kit.
MANTEL INSTALLATION CONTINUED Figure 12 - Installing Firebox on Hearth Base 7. Place the Cabinet Mantel Legs on Hearth Base and slide each side firmly up against the unit ( See Figure 13 ). NOTE: The Cabinet Mantel Legs and Hearth Base should be against the wall.
Figure 15 - Rough Opening for Installing in Wall MANTEL INSTALLATION CONTINUED 9. Lower Mantel top onto legs and header to com- plete installation of mantel.
BUILT-IN INSTALLATION CONTINUED If installing in a corner, use the dimensions shown in Figure 16 below for the rough opening. The height is 35", which is the same as the wall opening in Figure 15, page 18. 2. Install gas piping to fireplace. NOTE: This unit give (2) options on where the gas line can be ran into the fireplace.
LOG ASSEMBLY LOG POSITIONING This unit is supplied with a set of four ceramic fiber logs. Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any traces of fibers.
OPERATING INSTRUCTIONS Avoid any drafts that alter the burner flame patterns. Do not allow fans to blow directly into the heater. Do not place a blower inside burn area of fireplace. Ceiling fans may create drafts that alter burner flame patterns. Sooting and improper burning will occur.
1. Open access door. 2. Set front burner to Min. and turn off the rear burner by depressing knob and rotating clockwise until stop. 3. Unplug all electric power (optional blower) if service is to be performed. 4. Push in gas control knob slightly and turn clockwise to "OFF".
OPERATING INSTRUCTIONS, CONTINUED MATCH LIGHTING INSTRUCTIONS If the pilot will not light using the piezo ignitor, you can light the pilot with a match. First, locate the pilot. The pilot is located between the two burner tubes on the right end (facing the unit), inside the firebox.
CLEANING / SERVICING, CONTINUED Periodic Cleaning • Do not use cleaning fluid to clean logs or any part of heater. • Logs - Brush with soft bristle brush or vacuum with brush attachment. • Vacuum loose particles and dust from the front and rear burner, control, and piezo.
PARTS DIAGRAM AND PARTS LIST 25 KEY DESCRIPTION PART# QTY. 1 CABINET BOTTOM 24651 1 2 FIREBOX BACK 24652 1 3 FIREBOX LEFT SIDE 24653 1 4 FIREBOX RIGHT SIDE 24654 1 5 FIREBOX BOTTOM 24655 1 6 FIREBOX T.
5 16 15 6 8 9 2 3 7 4 10 11 17 1 19 18 A B C D 20 13 14 12 GENERATOR ASSEMBLY PARTS DIAGRAM 26.
KEY PART # DESCRIPTION QTY. 1 24610 BURNER PLATE 1 2 24611 CONTROL BRACKET 1 3 81193 CONTROL VALVE (NATURAL) 1 81194 CONTROL VALVE (L.P.) 1 4 83251 10-24 x 1 SL ROD 2 5 83244 10-24 KEP NUT 2 • 83343.
Wiring Diagram For Optional VF32B Blower Kit BLOWER BLACK BLACK BLACK WHITE BLACK WHITE BLACK GREEN WHITE RHEOSTAT & JUNCTION BOX COVER 2X4 JUNCTION BOX TO POWER SUPPLY You may install the VF32B Blower Kit in the VFZC32 Vent-free Gas Fireplace.
OPTIONAL ACCESSORIES 29 You may purchase these fireplace accessories from your local dealer. If they can not supply these accessories, call United States Stove Company's Sales Department at 1-423-837-2100 for information. You can also write to the address listed on the back page of this manual.
OPTIONAL ACCESSORIES 30 Drawings are for illustration purposes only. Actual product may very in appearance. ALUMINUM TRIM KITS Model VF32PB - Polished Brass Trim Kit Model VF32SB - Satin Black Trim Kit The Trim Kits must be used when installing firebox with Cabinet Mantel or Face Mantel.
31 HOW TO ORDER REPAIR PARTS This Manual will help you obtain efficient, dependable service from your Vent-Free Zero-Clearance Gas Fireplace, and enable you to order repair parts. Keep this manual in a safe place for future reference. When writing, always give the full model number which is on the nameplate attached to the fireplace.
32 C O M P A N Y U N I T E D S T A T E S S T O V E C S S U Keeping America Warm Since 1869 United States Stove Company 227 Industrial Park Road P.O.Box 151 South Pittsburg, TN 37380 (423) 837-2100 Save this manual for future reference.
デバイスUnited States Stove VFZC32Nの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
United States Stove VFZC32Nをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはUnited States Stove VFZC32Nの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。United States Stove VFZC32Nの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。United States Stove VFZC32Nで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
United States Stove VFZC32Nを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はUnited States Stove VFZC32Nの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、United States Stove VFZC32Nに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちUnited States Stove VFZC32Nデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
