Hondaメーカー08E92-SNA-100Bの使用説明書/サービス説明書
ページ先へ移動 of 20
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 1 of 21 08E92-SNA-1B00-91 FEB 2008 200 6-2008 CIVIC 4-DOOR (A/T ONLY) REMOTE ENGINE STARTER SYSTEM INSTALLATION INSTRUCTIONS Accessory Application Publications No.
2 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 7 Foam cushion tapes Flange nut Clip Green relay (5-pin) Template Illustration of the Engine Starter System.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 3 of 21 Setting the Control Unit 3. Get the control unit. Using a small flat-tip screwdriver, adjust the switches on the control unit to the locations shown. Using a isopropyl alcohol on a shop towel, clean the area where the protective tape will attach.
4 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 8. Remove the driver’s dashboard lower cover (eight clips). 5202121T DRIVER’S DASHBOARD LOWER COVER 8 CLIPS 7. If equipped, remove the driver’s dashboard under cover (turn the knob counterclockwise, and release two clips and pin).
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 5 of 21 9. Lower the tilt lever, and pull the steering wheel toward you. Insert a long blade flat-tip screwdriver along the guide of the column lower cover, and pry the retaining tab of the column upper cover.
6 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 1 3. Remove the sunvisor holders. Using a small flat- tip screwdriver, push the hook, and turn the holder 90°, then pull it out.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 7 of 21 1 8. Pull away the weatherstrip from the left front pillar trim. Remove the left front pillar trim (two clips). 5202100T 2 CLIPS LEFT FRONT PILLAR TRIM WEATHERSTRIP 1 9 .
8 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 23. Measure the antenna cable as shown. Attach the three foam cushion tapes to the antenna cable in the measurement shown. 2 4. Using isopropyl alcohol on a shop towel, clean the area where the antenna will attach.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 9 of 21 27. Route the antenna cable under the roof liner towards the driver’s side of vehicle, and down along the vehicle harness. Be careful not to crease the roof liner.
10 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 3 4. Install the four relays to the engine starter harness relay blocks. Be careful to install the relays properly, or a malfunction will result. Routing the Engine Starter Harness 3 3.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 11 of 21 3 7. Disconnect the vehicle 8-pin connector on the rear of the wiper switch and plug the engine starter harness 8-pin connector into the vehicle 8-pin connector.
12 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 3 9. Wrap the vehicle 7-pin connector with one foam cushion tape, then place the vehicle 7-pin connector into the gap of the column. 6D01111T VEHICLE 7-PIN CONNECTOR (brown) (Squeeze into this area.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 13 of 21 4 6 . Secure the engine starter harness to the vehicle harness using a wire tie. • With driver's dashboard under cover: Secure in the hole you made in the instrument panel.
14 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 5 0. Wrap foam cushion tape to the vehicle 2-pin and 4-pin connectors and secure them with a wire tie. Then, secure the vehicle harness with a wire tie. Reconnect the vehicle 42-pin connector.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 15 of 21 5 3. Install the clip from the engine starter harness to the fuse box bracket behind the fuse box. 6D01181T ENGINE STARTER HARNESS FUSE BOX BRACKET CLIP FRONT GROUND BOLT (Reuse.
16 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 6 0. Check that all wire harnesses are routed properly and all connectors are plugged in. 6 1. Reinstall all removed parts. Check that all clips and other fasteners are installed securely.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 17 of 21 752501AS CAR ICON 752502AS CHECK BUTTON Input the VIN and other required information. 752504AS Select “R/C ENG STARTER.” CHECK BUTTON 752503AS Select “Honda Systems.
18 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 752505AS “REMARKS” message CHECK BUTTON 752506AS Select “REGISTER REMOTE CONTROL ENGINE STARTER UNIT.” CHECK BUTTON 752507AS “Obtain PCM-code" message CHECK BUTTON 752509AS Input the PCM code.
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 19 of 21 752510AS "Registration" message CHECK BUTTON 752511AS “Check that the engine can be started by the Transmitter” CHECK BUTTON 1 1.
20 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 732904A Y DISPLAY COMMAND BUTTON START BUTTON TRANSMITTER STOP BUTTON FUNCTION CHECK Operating Conditions • The hood is closed. • Shift lever is in Park.
デバイスHonda 08E92-SNA-100Bの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Honda 08E92-SNA-100Bをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHonda 08E92-SNA-100Bの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Honda 08E92-SNA-100Bの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Honda 08E92-SNA-100Bで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Honda 08E92-SNA-100Bを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHonda 08E92-SNA-100Bの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Honda 08E92-SNA-100Bに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHonda 08E92-SNA-100Bデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
