JuraメーカーE70の使用説明書/サービス説明書
ページ先へ移動 of 19
IMPRESSA E70/75 Instructions for use 2/02 Art. Nr. 62564.
Jura Impressa E70/75 English ................................................................................................................ 6 – 19 Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. = Note = Important = Tip Jura Elektroapparate AG, CH-4626 Niederbuchsiten, Internet http://www.
Fig. 1 Fig. 4 Fig. 7 Fig. 2 Fig. 5 Fig. 8 Fig. 3 Fig. 6 Fig. 9.
7 8 9 11 12 13 14 15 16 17 18 6 5 4 3 2 1 10 8 8b 8a Operating elements Jura Impressa E70/75 1 Water quantity switch 2 Powder coffee selection switch 3 Coffee key for 2 cups 4 Rinsing-, cleaning-, des.
5 Contents Jura Impressa E70/75 1. Description .................................................. page 6 2. Safety instructions ........................................ page 6 2.1 Warnings .............................................. page 6 2.2 Safety precautions .
6 Important information for the user Thank you for choosing this Jura product. Please study these instructions carefully before using your new machine for the first time and keep them in safe place for easy reference in future.
7 3. Preparation of the machine 3.1 Checking the mains voltage The machine is set to the correct voltage before leaving our factory. Ensure that your mains voltage corresponds to the details quoted on the rating plate attached to the bottom of the machine.
8 The symbols on the display mean: HARDNESS LEVEL — Water hardness function switched off HARDNESS German water hardness 1 – 7° LEVEL 1 French water hardness 1.79 – 12.53° HARDNESS German water hardness 8 – 15° LEVEL 2 French water hardness 14.
9 6. Adjusting the water quantity The water quantity can be infinitely adjusted with rotary knob (1). The small key means little water for espresso, the large cup means a lot of water for coffee.
10 Never use water-soluble instant coffee or quick coffee. We recommend that you only use powder from freshly ground coffee beans or pre-ground, vacuum-packed coffee. Never put more than 2 portions of coffee in. The filler funnel is not a storage container.
11 When you have reached the required quantity of hot water, turn the steam/hot water rotary knob (15) back to the position . SELECT PRODUCT At the start of a water draw-off, there can be splashes. The pivoting nozzle gets hot. Please avoid direct contact with the skin.
12 12.4 Fill beans FILL BEANS Fill beans as described in Chapter 3.4. The display FILL BEANS only goes off after coffee has been drawn off. We recommend cleaning the bean container from time to time with a dry cloth before you refill beans. Switch the machine off for this purpose.
13 12.8 Insert filter Pull up the cartridge holder. Pressing gently, put the filter cartridge into the water tank (Fig. 7). Close the cartridge holder until it engages audibly. Fill the water tank with cold fresh tap water and put it back into the machine.
14 12.10 General cleaning instructions Never use abrasive articles or corrosive chemicals to clean your machine. Wipe down the casing on the inside and out using a soft, damp cloth. Clean the pivoting nozzle after each use. After heating milk, draw off a little hot water in order to clean the inside of the pivoting nozzle.
15 ADD TABLET (Fig. 9) / PRESS RINSE UNIT CLEANING / PLEASE WAIT An acoustic signal can be heard. EMPTY TRAY Wait for about 10 seconds before you put the drip tray back in again. PRESS RINSE UNIT CLEANING / PLEASE WAIT An acoustic signal can be heard.
16 FILL WATER / OPEN TAP / PRESS RINSE Turn the selector switch for coffee or hot water / steam (13) to position and press the rinsing key . UNIT DECALCING / PLEASE WAIT An acoustic signal is heard.
17 17. Messages Cause Action SYSTEM EMPTY System empty Fill system (see point 4.1) FILL WATER The tank is empty Fill with water Floater defective Rinse out or descale water tank FILL BEANS The bean container is empty Fill up with beans Although beans have been poured in, Draw off a cup of coffee.
18 18. Problems Problem Cause Action Grinder is very noisy – foreign body in grinder – Drawing off coffee with pre-ground powder – is still possible – Have machine examined by Jura service cen.
19 20. Technical data Voltage: 230V AC Power consumption: 1350 W Fuse: 10 A Safety check: Energy consumption standby: approx. 3 Wh Energy consumption ready to make coffee: approx.17 Wh Pump pressure: max. 15 bar Water tank: 1.9 litres Capacity, bean container: 200 gr.
デバイスJura E70の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Jura E70をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはJura E70の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Jura E70の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Jura E70で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Jura E70を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はJura E70の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Jura E70に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちJura E70デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。