AutostartメーカーAS-1725 SHの使用説明書/サービス説明書
ページ先へ移動 of 20
AUTOMATIC TRANSMISSION REMOTE STARTER AS-1725 SH Installation Guide Notice The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, be that either damage to the vehicle itself o r to the Unit.
P. 2 Installation Guide AS-1725 SH Table of Contents Table of Contents ...................................... 2 Introduction ................................................ 2 Included in the Kit ...................................... 2 Installation Points to Remember .
AS-1725 SH Installation Guide P. 3 x 1 – User Guide The plug-in Valet button is not included with t his Remote Car Starter. INDUSTRY CANADA USER NOTICE: Operation is subject to th e following tw o c.
P. 4 Installation Guide AS-1725 SH Wiring a Clutch Bypass and a Transponder Module to the GROUND OUT WHEN RUNNING wire: At the junctio n point, where the GROUND OUT WHEN RUNNING wire “splits” and connects to each device, a diode is inserted on each of these lines.
AS-1725 SH Installation Guide P. 5 This wire will power the Heater Blower Motor. Usually connected to the Accessories wire of the vehicle. The source wire must have power with the Ignition Key in the IGNITION ON (RUN) position only ( no power in the CRANK position).
P. 6 Installation Guide AS-1725 SH 12-Pin Accessories Harness Wire Colour Function Description 1 BLUE (–) Trunk / AUX 3 output 500 mA negative output.
AS-1725 SH Installation Guide P. 7 9 PURPLE (–) External Trigger The External Trigger wire can be used for remote-starting the vehicle with an external device.
P. 8 Installation Guide AS-1725 SH 12 YELLOW (+) Glow-Plug input In Diesel Mode, this positive input will monitor the Glow Plug Light: it will wait for up to 18 seconds until the Glow-plug Light goes out before allowing the Remote Car Starter to proceed to cranking the Engine.
AS-1725 SH Installation Guide P. 9 2-Pin Harness Wire Colour Function Description 1 BLUE/ WHITE (–) N/A This pin is not used. Leave it empty. 2 YELLOW (–) Parking Light output 500 mA negative Parking Light output Note: Ensure that the voltage does not vary when the dimmer control switch is turned up or down.
Remember: Once the Parking Lights are ON (solid), you have up to 20 seconds to selec t a sub-menu. If you do not select a sub-menu within 20 seconds, the Remote Car Starter will exit Programm ing Mode and you will have to flash th e Hood Pin switc h once again.
AS-1725 SH Installation Guide P. 11 To program a Transmitter on the second vehicle for Multi-car Operati on, you must press the TRUNK and LOCK buttons simultaneously (instead of LOCK or UNLOCK ) in st.
P. 12 Installation Guide AS-1725 SH Programming Options MODE 1 * INDICATES DEFAULT SE TTING FUNCTION 1 – Ignition-controlled Door Locks OPTION 1* Ignition Lock DISABLED OPTION 2 Ignition Lock ENABLED OPTION 3 Ignition UNLOCK ONLY OPTION 4 Ignition LOCK ONLY FUNCTION 2 – Secure Lock OPTION 1* Secure Lock DISABLED (1-sec.
AS-1725 SH Installation Guide P. 13 OPTION 2* Ignition Valet ENABLED OPTION 3 Ignition Valet ENABLED MODE 3 * INDICATES DEFAULT SE TTING FUNCTION 1 – Home Valet TM OPTION 1 Home Valet ENABLED OPTION 2* Home Valet DISABLED OPTION 3 Home Valet DISABLED FUNCTION 2 – AUX 3 / Zone 3 Programmin g OPTION 1 1-sec.
P. 14 Installation Guide AS-1725 SH of certain Ignition systems are sometimes too low or too hi gh for the Remote Car Starter, causing failed start-ups at var ious temper atures. 1. Flash the Hood Pin switch (see Table 1) – The Parking Lights will stay ON for up to 20 seconds.
AS-1725 SH Installation Guide P. 15 a. To increase the H orn pulse by 3 ms, press the LOCK button. b. To decr ease the p ulse by 3 ms, pr ess the UNLOCK butto n. c. To increase the pulse by 10 ms, pr ess the START or STOP button. d. To decrease the pulse by 10 ms, press the TRUNK button.
Closing Up Use tie-wraps or screws to properly secure the Remote Car Starter and kee p the wiring away from any moving parts such as the Parking Brake s or Steering Column S hafts. Mount all sw itches in good and acces sible locations where they do not ri sk getting kic ked or hit accidentally.
AS-1725 SH Installation Guide P. 17 Secure Lock This feature allows the Remote Car Starter to control certa in OEM factory Alarm systems without requiring the use of oth er wires for disarming the OEM Alarm. (Namely, this featu re is designed for OEM systems which use the factory Lock wire to arm the Alarm and the Unlock wire to disarm it.
P. 18 Installation Guide AS-1725 SH x Active Arming : the Starter Kill will not arm autom atically. Press the LOCK button t o arm and the UNLOCK button to disarm it. x Passive Arming: the S tarter Kill will arm automatic ally if it is not armed by remot e within a 60-sec.
AS-1725 SH Installation Guide P. 19 Start Failure Codes through the Parking Lights 1 x = No Start 3 x = Hardware Reset 4 x = Brakes 5 x = No Tach Cut-off 6 x = Hood 7 x = Engine Running, no Ignition d.
P. 20 Installation Guide AS-1725 SH Constant flashes up to 30 sec. x Panic Mode is triggered..
デバイスAutostart AS-1725 SHの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Autostart AS-1725 SHをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAutostart AS-1725 SHの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Autostart AS-1725 SHの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Autostart AS-1725 SHで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Autostart AS-1725 SHを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAutostart AS-1725 SHの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Autostart AS-1725 SHに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAutostart AS-1725 SHデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。